Specification Sheet

D-1030
A42046 – Rev. I – 05/2015
KB ELECTRONICS, INC.
12095 NW 39th Street, Coral Springs, FL 33065-2516
[phone] • Fax [phone] Outside Florida Call Toll Free [phone]
[e-mail] • www.kbelectronics.com
Represented by:
Notes: 1. Multi-Function Input Terminals (MFIT 1 – 5 on TB1 of the drive) are factory set for N.O. Contacts or NPN Transistors (J1 set to the “N.O. / NPN” position), which use the internal
power supply. For NPN Transistors, which use an external power supply (5 – 24 Volts DC), set Jumper J1 to the “EXT” position. For PNP Transistor circuits, which use the internal power
supply or an external power supply (5 – 24 Volts DC), set Jumper J1 to the “PNP” position. 2. Multi-Function Output Relay Contact Ratings: 1 Amp at 30 Volts DC, 0.5 Amp at 125 Volts AC,
and 0.25 Amp at 250 Volts AC. 3. Multi-Function Input Terminals (MFIT 6 – 7 on TB4 of the IODF) only accept N.O. Contacts or NPN Transistors (which use the internal power supply).
(0 - ±5 / ±10 Volts DC, 0 - 20 / 4 - 20 mA DC)
Analog Signal Input
(0 - 5 Volts DC)
Analog Output
5 - 24 Volts DC Input
J2
Multi-Function
N.O. / NPN
Type Selection
Signal Input
Multi-Function Input
Type Selection
EXTCUR
VOLT PNP
ANLG
PWM
5V
10V
J1
(MFIT 1 - 5)
1
Input Terminals
10
12
11 Common
9
8
7
MFIT 5
MFIT 3
MFIT 4
Ground (Earth)
Potentiometer
(5k Ohm Min.)
Remote
Main Speed
5
6
4
MFIT 1
MFIT 2
Common
3
2
TB1
1
(1 mA Max.)
+5 Volts DC
-5 Volts DC
(1 mA Max.)
AC Line Input
(Varies by Model)
L1
GND
(Chassis)
L3 / N
L2
Multi-Function Expansion Module
IODF Input/Output
Optional
0 - 25 Volts DC
Shield (Connect to GND Terminal)
Common
Signal Input
19
18
Multi-Function
Open Collector Output
14MFIT 6
Common
+5 Volts DC
(1 mA Max.)
MFIT 7
16
17
15
N.C.
TB1
13
TB3
Multi-Function
Input Terminals
Output Relay
Ground (Earth)
Ground (Earth)
Multi-Function
Contacts
2
Output Relay
2
Multi-Function
Motor
Scaling Trimpot
Signal Input
COM
N.O.
N.O.
COM
N.C.
TB2
U
GND
(Chassis)
W
V
(MFIT 6 - 7)
3
General Connection Diagram
FOW – 3K – 5/2015