Installation Manual

26
TABLE 7
DRIVE INPUT AND OUTPUT CONNECTIONS
1
Terminal Blocks No. Description Specifications
1 Power Supply –5 Volts DC at 1 mA Max.
2 Power Supply +5 Volts DC at 1 mA Max.
3 Analog Signal Input
0 – ±5 / ±10 Volts DC,
0 – 20 / 4 – 20 mA DC
4 Common
2
──
5 MFIT 1
6 MFIT 2
7 MFIT 3
8 MFIT 4
9 MFIT 5
N.O. Contacts or NPN / PNP Transistors
7 Preset Frequencies,
Up Frequency Command,
Down Frequency Command,
Accel/Decel #2,
Forward/Stop Command,
Reverse/Stop Command,
External Fault (N.O. Contact), Reset, N.O.
Start (2-Wire or 3-Wire Start/Stop), N.C.
Stop (3-Wire Start/Stop),
External Fault (N.C. Contact)
10
External
Power Supply Input
5 – 24 Volts DC Input
11 Common
2
──
TB1
on Drive
312 456 8791110 12
12 Analog Output 0 – 5 Volts DC
13
Open Collector
Output
NPN
14 MFIT 6
15 MFIT 7
Same As
MFIT 1 – MFIT 5 Above
16 Common
2
──
17 Power Supply +5 Volts DC at 1 mA Max.
18 Analog Input #2 0 – 2.5 thru 0 – 25 Volts DC
TB1
on IODF
19 Common
2
──
N.O. Normally Open
COM Relay Common
3
TB2
on Drive
TB3
on IODF
N.C. Normally Closed
Run, Fault,
Target Frequency (5.03 ± 5.04),
Frequency Threshold Level (> 5.03 –5.04),
Frequency Threshold Level (< 5.03 +5.04),
I
2
t or I•t Fault, Load Loss (See 5.05),
External Fault
Notes: 1. For additional inputs and outputs, install the optional IODF Input/output Multi-Function
Expansion Module (Part No. 9646). See Appendix A, on page 64. 2. Common Terminals "4",
"11", "16", and "19" are internally wired together. 3. Relay Commons are not internally wired to
Common Terminals "4", "11", "16", and "19".