Instructions / Assembly

Page 3 of 5

INSTALLATION (continued)

Installing the mounting plate

• Place the flat side of the bracket plate (H1) over

the outlet box, secure the bracket plate (H1) on

the outlet box with two outlet box screws (H2)

(Do not lock too tight) and adjust the bracket

plate (H1) to the desired location, and then make

the location on the two key holes with a pencil

(not provided). Remove the bracket plate (H1)

from the wall.

• Drill a small hole on each mark and push the

plastic anchors (H4) into the ceiling using a

hammer.

• Fasten the bracket plate (H1) onto the outlet

box using 2 outlet box screws (H2). Place the 2

wood screws (H5) in the key holes located on the

bracket plate (H1) and tighten until fully secured.

NOTE: If your wall is wood, do not drill holes. Use

the two wood screws (H5) and two outlet box

screws (H2) to secure the bracket plate (H1).

Making the electrical connections

• Strip 3/4 in. of insulation from the wire ends.

• Connect the black wire from the fixture to the black wire from the outlet box, then connect the white

wire from the fixture to the white wire from the outlet box.

• Connect the bare copper ground wire to the ground wire from the outlet box. The bare copper ground

wire from the fixture must loop one turn under the head of the green ground screw (H5) on the mounting

bracket (H1) before it is connected to the ground conductor of the supply circuit.

• Cover the wires with wire connectors (H6). Tape the wire connectors (H6) and wires together, and

carefully position all wires inside the outlet box.