Instructions / Assembly

ManualsBrandsKAWOTI ManualsLighting1-Light Modern Matte Black Pendant Light with Clear Glass Shade

USE AND CARE MANUAL

1 LIGHT PENDANT

THIS MANUAL CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND

KEEP FOR FUTURE REFERENCE.

Page 1 of 4

Hardware

(Parts are not to scale)

Mounting strip

(Pre-assembled to canopy

assembly (A))

1 pc

Support screw (long)

(Pre-assembled to mounting

strip (H1))

2 pcs

Hex nut

(Pre-assembled to

support screw (long) (H2))

2 pcs

Outlet box screw (short)

2 pcs

Green ground screw

(Pre-assembled to

mounting strip (H1))

1 pc

Wire connector

3 pcs

Cap nut

(Pre-assembled to

support screw (long) (H2))

2 pcs

Socket ring

(Pre-assembled to socket of

socket assembly (C))

1 pc

Plastic screw

(Pre-assembled to canopy

assembly (A))

1 pc

GNDGND

Summary of content (4 pages)

PAGE 1
USE AND CARE MANUAL 1 LIGHT PENDANT A B C D H1 Mounting strip (Pre-assembled to canopy assembly (A)) 1 pc H4 Outlet box screw (short) 2 pcs Hardware (Parts are not to scale) GND H2 Support screw (long) H3 Hex nut 2 pcs H5 Green ground screw 2 pcs (Pre-assembled to mounting strip (H1)) (Pre-assembled to mounting strip (H1)) (Pre-assembled to support screw (long) (H2)) H6 Wire connector 3 pcs H7 Cap nut 1 pc H8 Socket ring H9 Plastic screw 2 pcs 1 pc 1 pc (Pre-assembled to support screw (
PAGE 2
IMPORTANT SAFETY INFORMATION • Please read and understand this entire manual before attempting to assemble, operate or install the product. • Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). • Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
INSTALLATION (continued) 3 Assembling the tube 4 Adjusting the power cord • Fasten the tube (B) into the top of the socket assembly (C). • Loosen the plastic screw (H9) on the canopy assembly (A) by using a flat head screwdriver (not provided) and adjust the fixture wire to the desired length, then tighten the plastic screw (H9) back into the hole as shown in the diagram. A B H9 C 5 Making the electrical connections • Strip 3/4 in. of insulation from the wire ends.
PAGE 4
INSTALLATION (continued) the canopy assembly Installing the glass shade and 6 toInstalling 7 the outlet box light bulb • Place the canopy assembly (A) over the outlet box, and ensure the heads of the support screws (long) (H2) come through the holes of the canopy assembly (A). • Unscrew the socket ring (H8) from the socket of socket assembly (C), place the glass shade (D) onto the socket and secure with the socket ring (H8).