® Electronic Drum/Percussion Pad Sound Module ktmp1 Owner’s Manual
INFORMATION FOR YOUR SAFETY! PRECAUTIONS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. PLEASE READ CAREFULLY BEFORE PROCEEDING Please keep this manual in a safe place for future reference.
Contents 1. Overview 3 2. Panel Description 3 2.1 Front Panel Description 3 2.2 Rear Panel Description 4 3. Basic Operations 5 3.1 Adjust the pad voice tuning 5 3.2 Adjust the reverb level 5 3.3 Assign an instrument to a pad 5 3.4 Adjust the panning of pad voices 6 3.5 Adjust the sensitivity of a pad 6 3.6 Adjust the level of a pad 6 3.7 Adjust the midi note of a pad 7 3.8 Assign a pad to HI-HAT pad control 7 4. Appendixes 8 4.1 Voice List 8 4.
1. Overview The KAT KTMP1 is a self-contained electronic percussion instrument with four drum pads, 50 sounds, audio and trigger I/O. The product is mountable using the included Module Mount or a standard snare drum stand for use in drum, percussion, and other performance setups.
AUTO POWER OFF: The digital drum will automatically turn off the power if there is no operation after 30 minutes. Press the [SELECT +] and [SELECT -] buttons and then turn on the power to switch off the auto power off function. It will display “oF” briefly. 2.2 Rear Panel Description 10 9 11 14 12 13 9. [PHONE] Jack: Connect to headphone. 10. [LINE OUT] Output: Connect to external AMP. 11. [HI-HAT PEDAL] Jack: Connect to a HI-HAT Pedal controller.
Typical Plug-in Scenarios Electrical Power Supply (supplied) USB 2.
3. Basic Operations 3.1 Adjust the pad voice tuning Press: [SELECT+] or [SELECT-] button to select the tune mode, the TUNE LED will light up, when striking a pad, the 2-Digi-LED will display the tune level, press the [VALUE +] or [VALUE -] to adjust the tune level. [-4,-3,-2, -1, 00, 01, 02,03,04] The display is: 3.
3.4 Adjust the panning of the pad voice Press: [SELECT+] or [SELECT-] button to select the pan mode, the PAN LED will light up, when striking a pad, the 2-Digi-LED will display the pan level, press the [VALUE +] or [VALUE -] to adjust the pan level. [L4,L3,L2, L1, C, R1, R2,R3,R4] The display is: 3.
3.7 Adjust the midi note of a pad Press: [SELECT+] or [SELECT-] button to select the midi note mode, the MIDI NOTE LED will light up, when striking a pad, the 2-Digi-LED will display the midi note number, press the [VALUE +] or [VALUE -] to adjust the midi note number. [00~99] The display is: Note: the midi note will change according to the voice number. 3.8 Assign a pad to HI-HAT pad control 1. Enter HI-HAT function: 1.1 Strike a pad (PAD1-4) to be assigned. 1.
4. Appendixes 4.1 Voice List Voice List: No.
4.
