User guide

K A S P E R S K Y M O B I L E S E C U R I T Y 8 . 0
72
BLOCKING ACCESS TO ENCRYPTED DATA
You can block access to encrypted data instantly or with a delay. After this you will have to enter your secret code to
access the encrypted data.
To ensure data protection when the device is switched into the sleep mode, you can configure automatic blocking of data
access.
The Block access setting determines the device's idle time after the backlight is turned off and the device is switched to
the sleep mode, after which you will need to enter the secret code to access the encrypted data.
By default the access is blocked immediately after the backlight is turned off (value No delay is selected).
To enable delayed blocking, perform the following actions (see Figure below):
1. Select Settings on the Encryption tab.
2. Select Block access in the window that will open.
3. Set up the time you wish: 1 minute, 5 minutes, 15 minutes or 1 hour.
4. Press OK to save changes.
Figure 61: Blocking access to encrypted data
You can also instantly block access to the encrypted data and enable the prompt for the secret code.
For instant access blocking,
press buttons 0 and 1 at the same time.