User guide

K A S P E R S K Y M O B I L E S E C U R I T Y F O R M I C R O S O F T W I N D O W S M O B I L E
139
DATA DECRYPTION
You can completely decrypt data which was previously encrypted (see section “Data encryption” on page 137).
For full decryption of the folder encrypted earlier,
select Decrypt on the Encryption tab (see Figure below).
Figure 121: Data decryption
After decryption, the Decrypt item will turn into Encrypt and you can use it again to encrypt data (see section “Data
encryption” on page 137).
BLOCKING ACCESS TO ENCRYPTED DATA
To ensure data protection when the device is switched into the sleep mode, you can configure functioning of the secret
code.
You can configure an idle time delay for the secret code or to configure an immediate prompt for the secret code.
Idle time delay – device's idle time after the backlight is turned off and the device is switched to the sleep mode, after
which you will need to enter the secret code to access the encrypted data.
By default the idle time delay is disabled (value No is set), therefore, immediately after the backlight is turned off, you
need to enter the code to access the encrypted data.
To enable the idle time delay, perform the following actions (see Figure below):
1. Select Settings on the Encryption tab.