User Guide

66 Kaspersky Administration Kit
5. A set of files required for installing this application on clients is then
loaded to the shared folder on the administration server. The server
checks the administrator workstation for the availability of the Console
Plug-in for this application. If the plug-in has not been installed or its
version is earlier than that of the application, it will be installed or
replaced.
The Network Agent installation package is created automatically
during Kaspersky Administration Kit installation. The package
can be found in the Remote install node.
If you accidentally deleted the Network Agent installation
package, to create it again, select the klnagent.kpd file in the
NetAgent folder of the Kaspersky Administration Kit installation
package as a definition file.
After you finish with the wizard, a new installation package will be added to the
Remote install node and displayed in the details panel.
5.3. Configuring installation package
settings for the Network Agent
In order to configure the settings of the Network Agent installation
package:
select the Settings tab (see Figure 37) in the installation package settings
configuration window.
This tab displays the following settings related to the Network Agent's op-
eration:
• Connection settings used to connect to the corresponding
Administration Server – in the Server connection field group (details
see section 6.3 on page 100).
• address of the computer on which the Administration Server is
running.
• port number used to connect to the server.
• port number that will be used to connect to the new Administra-
tion Server through SSL protocol. To enable the SSL connec-
tion, check the Use server SSL connection box.
• Administration Server certificate file used for authentication of
access to the new Administration Server;