User Guide
98 Kaspersky Anti-Virus® for Sendmail with Milter API
LicensedUsersDomains – list of domains containing accounts which
should be protected, according to the licensing scheme of Kaspersky
Anti-Virus for Sendmail with Milter API. This option is available only if
your license is issued for a certain number of mail addresses.
The [kavmilter.snmp] section contains parameters defining the interaction with
application via the SNMP protocol:
SNMPServices=config|statistics|admin|update|all|none – application
information that can be accessed over SNMP.
You can set several values for this parameter as shown in the following
example:
SNMPServices=config
SNMPServices=admin
SNMPTraps=config|admin|update|all|none – list of events which trigger a
notification to administrator via SNMP-traps.
AlertThreshold=0…100 – threshold percentage of infected messages in all
messages scanned during the last hour which when exceeded will
trigger an SNMP-trap sent by the application (in case the SNMPTraps
parameter is set to admin).
The [kavmilter.agentx] section contains the AgentX protocol parameters for the
SNMP subagent.
Socket – the socket which is used to interact via AgentX protocol; both local
and network socket can be specified here.
Timeout – timeout (in seconds) for requests sent to master agent.
Retries – number of attempts for requests sent to master agent.
PingInterval – time interval (in seconds) between attempts by the subagent
to connect to the master agent, if the connection fails.
The [kavmilter.engine] section includes parameters defining the scanning
procedure:
MaxScanRequests – the maximum number of requests for scanning
messages. If the parameter is 0, the number of requests is unlimited.
MaxScanTime – the maximum time, in seconds, which the application can
spend scanning a single object (a message or a message object). If the
value is exceeded, the application returns an error.
ScanArchives=yes|no – scan archives. To disable this mode, set the
parameter to no.
ScanPacked=yes|no – scan packed executables. To disable this mode, set
the parameter to no.