User Guide

Additional setup 49
7.2. Installing and uninstalling the
Webmin module of Kaspersky
Anti-Virus
You can configure Kaspersky Anti-Virus settings and stop/start anti-virus tasks
from a remote location using web-based interface of Webmin application. To
enable remote management, you should install the Webmin application, install
the Kaspersky Anti-Virus module for Webmin, and configure the application.
For instructions on how to install Webmin, refer to the documentation
for this product.
To install the Kaspersky Anti-Virus module for Webmin, follow these steps:
1. Connect to web-interface of Webmin application using your browser.
2. Select Webmin Configuration and open the Webmin Modules
configuration section.
3. In the Install Module section, select installation from file (from local
file) and specify the full path to kavmilter.wbm, the Kaspersky Anti-Virus
module for Webmin in the corresponding field.
For Linux, the module is located in:
/opt/kav/5.6/kavmilter/web/kavmilter.wbm;
for FreeBSD and OpenBSD, the module is located in:
/usr/local/share/kav/5.6/kavmilter/web/kavmilter.wbm.
4. Click Install Module From File.
As the result, the KAV for Milter module will be added to the Others tab.
After installation, open the module (Others Æ KAV for Milter), switch to the
Module Config tab and check whether the paths to the main Kaspersky
Anti-Virus files and directories are specified correctly.
Then, you can set up operation of the Anti-Virus with the Webmin application.
For example, using Webmin, you can limit access to the Anti-Virus by setting up
user passwords (about Webmin settings, see the documentation for this
product).