User Guide

CHAPTER 7. ADDITIONAL
SETUP
This section describes in detail additional setup of Kaspersky Anti-Virus
functionality. Unlike the settings made during the installation process (please see
section 3.3 on p. 22) which are required and essential for product functioning,
additional setup is performed at the administrator's discretion. Those settings
extend product functionality and allow its adjustment for operation in accordance
with your corporate security policy.
7.1. Integrating the application into
your mail system
If the application has not been integrated with Sendmail during installation, use
kavmilter-setup.sh, a special utility for integrating Kaspersky Anti-Virus with your
mail system. Sendmail needs to be restarted after you make necessary
configuration changes. You can also roll back to the previous Sendmail
configuration if needed.
Use the following command line options:
–sendmail-cf <file> – use an alternative CF Sendmail configuration file.
–sendmail-mc <file> – use an alternative MC Sendmail configuration file.
–add-filter – change the Sendmail configuration file.
–del-filter – roll back to the previous Sendmail configuration and cancel the
latest changes.
–check-filter – check whether the kavmilter filter has been added to
Sendmail configuration. If the filter has been successfully added, the
console will display yes; otherwise the value will be no.
–set-filter <action> – specify further actions to be performed by Sendmail if
the kavmilter filter is unavailable (specified limits have been exceeded, a
cold restart has occurred, etc.). These actions are recorded in the mail
system configuration in the filter definition section. Here are some
possible actions:
tempfail – the client connection shall fail with error 451 (for example,
451 4.7.1 Please try again later);
reject – any incoming messages shall be rejected. The error return
code is 554 (for example, 554 Not accepting messages);