User Guide

AntiViral Toolkit Pro
- 58 -
Cannot Create AVPI main window
This message is displayed if there is not enough system resources to open
AVPI Main window.
7.3 Debugging registers test messages
AVPI performs a debugging registers test before beginning any checks.
During normal operation (not under a debugger) the system should not have any
hardware breakpoints set. The following messages may occur:
Hardware breakpoint detected at XXXX:XXXX
Ensure that no debuggers (like Turbo Debugger™, Soft ICE/W™ or
CodeView™) are running when AVPI runs, and there are no hardware
breakpoints left from your previous debugging sessions. If after you have
done that you still keep getting this message where breakpoint segment
address points to BIOS area (C000h - FFF0h) there could be a serious
problem! Try removing the breakpoints by pressing the “Remove” button.
Cannot access debugging registers
This message may be displayed during the debugging registers test and may
be caused by an active virus or a debugger that is running.
7.4 Other messages
The following messages are mostly debugging or diagnostic messages.
AVP Inspector for Web Servers requires AVPIChCk.DLL version
X.XX or later to operate correctly. Please use AVPIChCk.DLL from
AntiViral Toolkit Pro.
This message is displayed during AVP Inspector for Web Servers™ launch
if the version of AVPIChCk.DLL currently installed is lower than X.XX.
This is an AVP Inspector for Web Servers™ internal library.
AVP Inspector for Web Servers requires NKrnl32.DLL version X.XX
or later to operate correctly. Please use NKrnl32.DLL from AntiViral
Toolkit Pro.
This message is displayed during AVP Inspector for Web Servers™ launch
if the version of NKrnl32.DLL (NKrnlNT.DLL) currently installed is lower
than X.XX. This is an AVP Inspector for Web Servers™ internal library.