Product Manual

5
Parts included in RA(H)2-NC and RA(H)3-NC Sys-
tems:
(2) or (3) Robust-Aire Diffuser Assembly
(2) or (3) 3/8” x 100’ SureSink Tubing w/tting kit
(1) Double Head Compressor
(1) ¼” NPT x 3/8” barb brass elbow
(4) Compressor Vibration Isolation Feet
(1) 3’ length of 3/8” hose
(2) Hose clamp
(1) Two or Three Station Manifold Assembly
(2) Manifold Mounting Screw
Parts included in RA(H)4-NC, RA(H)5-NC and
RA(H)6-NC Systems:
(4 - 6) Robust-Aire Diffuser Assembly
(4 - 6) 3/8” x 100’ SureSink Tubing w/tting kit
(2) Double Head Compressor
(2) ¼” NPT x 3/8” barb brass elbow
(8) Compressor Vibration Isolation Feet
(2) 3’ length of 3/8” hose
(4) Hose clamp
(2) Two or Three Station Manifold Assembly
(4) Manifold Mounting Screw
Installation Tools & Materials
Phillips Screwdriver
5/16” socket wrench or Flat Screwdriver
PTFE thread sealant (Teon tape)
No Cabinet System Installation
Requirements
Correct installation is your responsibility. Make sure
you have the proper installation conditions and that
installation clearances do not block air ow.
Compressor needs to be installed in a clean, dry
location.
Compressor needs to be protected from dirt and
moisture and from the outdoor environment such
as rain, snow, ooding.
Ambient air temperature (temperature readings
taken 4” away from any surface of the compressor)
must not exceed 104° F (40°C).
Adequate ventilation and cooling air (air ow
across the compressor) must be provided to keep
the compressor from overheating and causing pre-
mature damage.
3/8” Lead hose from
compressor
3/8” Clamp
3/8” x 3/8” Barb Fitting or
3/8” x 5/8” Barb Fitting
3/8” or 5/8” Clamp
3/8” or 5/8” tubing
Caution: Do not over tighten clamps.
19. Trench and bury tubing from the compressor to the
shore.
-NC Systems
Parts included in RA(H)1-NC Systems:
(1) Robust-Aire Diffuser Assembly
(1) 3/8” x 100’ SureSink Tubing w/tting kit
(1) Single Head Compressor
(1) ¼” NPT x 3/8” barb brass elbow
(4) Compressor Vibration Isolation Feet
(4) ¼” Flat Washer
(4) ¼” Lock Nut
(1) 3’ length of 3/8” hose
(1) Hose clamp