Product Manual

5
STEP SIX (optional bottom screen)
Using a stainless steel Bottom Screen Clip (Part 11),
3/8”-16 x 1-3/8” Bolt (Part 7), two 3/8” Flat Washer
(Part 8), and 3/8”-16 Nylon Lock Nut (Part 12) to
secure the screen to the oat. Align a clip so the two
prongs straddle a wire on the screen. Insert bolt with
washer so the top of the bolt is facing the top of oat
(now in down position). Place the second washer and
the locking nut with nylon insert on the end of the bolt
and tighten using the 9/16” (14mm) Socket and Ratch-
et on the nut end and the 9/16” (14mm) Wrench on the
bolt end. Tighten until snug and repeat with remaining
clip.
STEP SEVEN
Turn the assembly upright again. At this time, if the
cord contains a metal strain relief, you can use the
chain connector and attach it in one of the opening at
the rope placement. The chain connector will easily t
if installed from the bottom or top side of the opening.
It will not t if installed from side of opening. Use the
Nylon Cable Tie included to secure the power cord to
a molded hole in the oat to prevent cord damage if
there is no strain relief on the cord. If a Strain Relief
is present on the cord, you may disregard the Nylon
Tie. On cords with a Quick Disconnect, the discon-
nect should be tightened properly to avoid leaking.
If installing a new Quick Disconnect, refer to Quick
Disconnect Instructions.
STEP EIGHT(optional)
Thread one rope through one Pipe Weight and posi-
tion it approximately 6’ from the oat. Next, thread
the end of the rope back through the opening facing
the oat (as shown). Repeat with the second rope and
weight. If ready to install in the pond, go to Instal-
lation instructions. Light Kits can also be installed at
the at washer. Insert screw with washer through bolt
hole in oat
Use one oat retaining clip (Part 6) under the top ring
of the cage. There is a U-shaped indent in the clip that
will t snug against the top ring of the cage. The 1/4”-
20 x 3-1/2” will then thread into the retaining clip.
oat retain
ing clip
Tighten until snug with a Phillips Head screw driver
and repeat for 3 remaining screws.
STEP FIVE (optional bottom screen)
See “Mesh Screen Attachment” section before con-
necting the bottom screen to the oat. Turn secured
assembly upside down so the top of the oat (logo
side) is face down on the at surface. Place Bottom
Screen (Part 10) onto the bottom side of the oat.
Make sure the wide opening of the screen is against
the oat and the 3 handles on the screen do not in-
terfere with the rope placements. Fit the 3 Bottom
Screen cushion (Part 9) underneath the screen and on
top of the 3 spacing bumps on the bottom of the oat.
Bottom Screen cushion