Product Manual

ManualsBrandsKasco ManualsLawn & GardenMarine High Oxygen Pond Aerator — 3/4 HP, 240V, 100-Ft. Power Cord

tional C-25 (3) or C-85 (4)

• 9/16” Socket and Ratchet (for optional bottom

screen)

• 9/16” Wrench (for optional bottom screen)

• Nylon Tie for cord

2400AF, 3400AF/HAF, 4400AF/HAF Assembly

STEP ONE

Make sure you have all the parts needed. If any short-

ages are found, contact your Kasco representative

immediately.

STEP TWO

Set motor housing upright (stainless steel can down)

on a at surface. With motor housing upright, slide

Float (Part 2) over pump housing making sure the

surface with the Kasco logo is up.

logo

Rest the oat on the cage top ring.

STEP THREE

Ensure correct alignment by twisting the oat gently

around the motor housing until the power cord guide

lines up with the cord. See diagram of bottom side of

oat.

Bolt holes

power cord

guide

STEP FOUR

Use one of the 1/4”-20 x 3-1/2” Phillips Pan Head

Screws (Part 3), one 1/4” split washer (Part 4), and a

1/4” Flat Washer (Part 5) to secure the oat. Make

sure the split washer goes between the bolt head and

REV.

ECO#

DESCRIPTION

DR'N BY

DATE

DES ENG

CH'K BY

INITIAL RELEASE

XXXX-XXXX-XX

DO NOT SCALE DRAWING

C.A.D. GENERATED DRAWING

800 DEERE ROAD

PRESCOTT, WI 54021-1241

FX FLOAT ASSEMBLY W/SCREEN

THIS DRAWING CONTAINS PROPRIETARY

INFORMATION AND SHALL NOT BE USED,

REPRODUCED OR DISTRIBUTED WITHOUT

THE PRIOR WRITTEN CONSENT OF

KASCO MARINE, INCORPORATED

.02 [.508] .XX

.010 [.254]

.XXX

.005 [.127] ANGULAR

0.5

UNLESS OTHERWISE SPECIFIED

DIMENSIONS ARE IN INCHES.

DIMENSIONS IN [ ] ARE MILLIMETERS.

TOLERANCES ON:

THIS DOCUMENT HAS BEEN ISSUED

FOR ENGINEERING INFORMATIONAL

PURPOSES ONLY. ANY REVISIONS

TO THE CONTENT OF THIS DOCUMENT

MUST BE INCORPORATED INTO THE

ORIGINAL CAD FILE.

THIRD ANGLE PROJECTION

TITLE:

XXXX-XXXX-XX

SHEET 1 OF 1

FINISH:

MATERIAL:

SCALE: 1:24

DWG. NO.

Optional Equipment

• Control Box (C-25 for 120V units or C-85 for 240V

units in separate box) (1 - optional)

• Bottom Screen with mesh and Hardware for Small

Float Ring (1 - optional)

NOTE: Extra hardware may be included.

POND AERATOR TOOLS & SUPPLIES NEEDED

• Anchors or stakes for installing unit (2 or 3 depending

on unit)

• # 2 Phillips head screw driver

• Two (or 3 depending on model) 12” pieces of 1” galva-

nized pipe for weighting ropes (optional)

• #10 x 1” long or longer screw(s) for mounting the op-