User guide

11
STEP SEVEN
Insert the Spacer Bracket (Part B7)under the U-Brack-
et and inside the cage. Secure this assembly using one
1/4” x 1” Bolt (Part B9) and a 1/4” Lock Nut (Part
B11), and one 1/4” x 1-1/4” Bolt (Part B10) and a 1/4”
Hex Nut (Part B12). The longer bolt should be on the
side of the U-Bracket that is closer to the cord clamp.
Tighten the hardware using the 7/16” (11mm) wrench
and socket & wrench until the U-Bracket clamps
fi rmly around the cage (U-Bracket should pull together
slightly). Repeat with the second U-Bracket.
STEP EIGHT
Attach an Angle Bracket to each of the longer (1-1/4”)
bolts on the U-Brackets (See photo for orientation)
with a 1/4” Lock Nut.
2400 & 3400
4400 & 8400, 2.3
STEP NINE
Wrap the Draw Band (Part B5) around the motor
housing and position so that the back of the Draw
Band touches the marks drawn in Step Five. There is
no front or back to the Draw Band itself - it is revers-
ible. Orient the arm of the Draw Band so it aligns
with the cord clamp on the cage of the motor housing
and is parallel to the Angle Brackets attached in Step
Eight. Secure using a 1/4” x 1” Stainless Steel Bolt
and a 1/4” Lock Nut. (See photo in next column)
Models 2400
& 3400 - Angle
posterior to bolts.
Model 8400, 2.3
& 4400 Angle
anterior to bolts.
STEP FIVE
With a felt-tip marker, draw three to four marks
around the circumference of the motor housing at the
appropriate measurement from the back (or bottom) of
the motor housing given:
2400: 3/4” (1.9cm)
3400: 3-3/8” (8.57cm)
4400: 5-1/2” (14 cm)
8400, 2.3: 7-1/2” (19 cm)
STEP SIX
Place the two U-Brackets (Part B6) directly across
from each other (180
O
) over the top ring of the motor
cage. The cord clamp on the cage should be 90
O
from
each of the U-Brackets
.
1/4” x 1”
Bolt and
Locking
Nut
Power Cord1/4” x 1-1/4”Bolt
and Nut
1/4” x 1”
Bolt and
Locking
Nut
1/4” x 1-1/4”Bolt
and Nut