Manual
6
against the fl oat and the 3 handles on the screen do not
interfere with the rope placements.
Fit the 3 Bottom
Screen cushions (Part M) underneath the screen and
on top of the 3 spacing bumps on the bottom of the
fl oat.
Bottom Screen cushion
Using a stainless steel Bottom Screen Clip (Part
H), 3/8”-16 x 1-3/8” Bolt (Part G), two 3/8” Flat
Washer (Part E), and 3/8”-16 Nylon Lock Nut
(Part F) to secure the screen to the fl oat. Align a
clip so the two prongs straddle a wire on the
screen. Insert bolt with washer so the top of the
bolt is facing the top of fl oat (now in down posi-
tion). Place the second washer and the locking nut
with nylon insert on the end of the bolt and tighten
using the 9/16” (14mm) Socket and Ratchet on the
nut end and the 9/16” (14mm) Wrench on the bolt
end. Tighten until snug and repeat with remaining
clip.
STEP SIX
Turn the assembly upright again. At this time,
if the cord contains a metal strain relief, you
can use the chain connector and attach it in
one of the opening at the rope placement. The
chain connector will easily fi t if installed from
the bottom or top side of the opening. It will
not fi t if installed from side of opening. Use
the Nylon Cable Tie (Part I) included to secure
the power cord to a molded hole in the fl oat to
prevent cord damage if there is no strain relief
on the cord. If a Strain Relief is present on the
cord, you may disregard the Nylon Tie. On
cords with a Quick Disconnect, the disconnect
should be tightened properly to avoid leaking.
If installing a new Quick Disconnect, refer to
Quick Disconnect Instructions. If ready to in-
stall in the pond, go to Installation instructions.
3400EJ, 4400EJ Parts
Aerating Fountain (Unit with cord or unit with 1.
Disconnect) (1)
Float (with two 50’ mooring ropes attached) (1)2.
1/4-20 x 3 1/4” Phillips Pan Head Screw (4)3.
1/4” split washers (4)4.
1/4” (3/4” outer diameter) Flat Washer (4)5.
3/8”-16 x 1-3/8” Hex Head Bolt (2)6.
3/8” Flat Washer (4)7.
Float Retaining Clips (4)8.
Bottom Screen cushions (3)9.
Bottom Screen (1)10.
Bottom Screen Clips (2)11.
3/8”-16 Nylon Lock Nut (2)12.