Updating Playbase Unit to 4.
Connecting the USB • Hold the “+” volume button and the power button simultaneously and plug the unit to the PC
Opening RKAndroid Tool • Open RKAndroid_v1.29_For_1.33(APK1024M) folder on desktop and open file RKAndroidTool. (Make sure it is the 1.66 loader version) • Check all boxes except for Backup.
RKAndroid Tool • For “Misc, Kernel, Boot, Recovery and Systems”-Insert file name accordingly from “Image” folder on Desktop.
Recognizing the Hardware • If the PC recognises the hardware, it will show “Found RKAndroid Rock Usb”
RKAndroid Tool • Click on EraseIDB. A prompt will pop out once it’s done and click OK.
Updating the Software • Click “Run” and it will start downloading into the hardware. Once done, it will show a message “INFO: Run OK” • Wait for a few seconds for it to load into the hardware before unplugging.
Not Recognised Scenario • The RKAndroid Tool will state “No Found RKAndroid rock usb”
Not Recognised Scenario • A prompt will appear to install software • Check the “Install a list or specific Location (advanced) and click Next
Not Recognised Scenario • Check on the “Don’t search. I will choose the driver to install. Click Next.
Not Recognised Scenario • Click on RK29 Device and click Next. Once done click Finish, and hardware is ready to update. Go back to the 4th slide and start over.
Things to Take Note • For the first power on after update, it will take a few minutes, much longer than usual to boot into the main screen • Important! Wait a few seconds after update before unplugging-the software is booting into the system of the hardware. • Plug out only after the icon buttons of the unit starts flashing on and off.
