INSTALLATION GUIDE Venda Models: Karran USA KBF514C KBF514SS KBF514MB Tel: 866.452.7726 www.karran.com info@karran.
PARTS SHEET KBF514** 1 8 13 2 3 4 9 5 10 11 6 2 12 7 3 4 5 16 6 7 14 15 17 18 1 1. Handle 2. O-rings 3. Rubber Washers 4. Clamps 5. Mounting Nuts 6. Mounting Screws 7. Clamp springs 8. Faucet Body 9. O-ring 10. Rubber Washer 11. Clamp 12. Nut 13. Handle 14. Aerator Wrench 15. Allen Key 16. Quick Connect 17. Pop-up Drain 18.
TECHNICAL DRAWING 2
INSTALLATION GUIDE STEP 1 1. Position the o - ring (#9) and faucet body (#8) in the installation surface as shown and secure it with the r ubber washer (#10) and clamp (#11) and tighten the nut (#12) with adjustable wrench . 8 9 10 11 12 STEP 2 1 13 2 Hot 2 Cold 3 4 5 3 4 6 5 6 2.Position the o - ring (#2) and handle mounting (#1,#13) in installation surface as shown and secure it with kit (#3,#4,#5,#6) and tighten the screws with screwdriver. Repeat the above steps for the other handle.
INSTALLATION GUIDE STEP 3 1 8 13 3. Connect the “quick connect” hose (# 16 ) to the handle (#1 and #13) and faucet body (#8). You will hear a “click” when it has been successfully connected. Use the provided clamps (#7) to secure the ends of the “quick connect” hose. 16 7 STEP 4 7 COLD HOT 4.Connect the water supply lines to the bottom ends of the “quick connect” hose (#7) and to the hot and cold water supply valves. Secure and tighten with an adjustable wrench.
INSTALLATION GUIDE STEP 5 1 5. From the top of the drain hole,place the drain ① through the installation hole. From under the drain hole, install the thick washer ②,washer ③ and nut ④ by hand twisting on to the tail pipe of the drain. Then, install the tail pipe to the wall plumbing.Use of plumbers putty or silicone is recommended to seal drain ① to top side of bowl. 2 3 4 STEP 6 6. Remove the aerator with an aerator wrench (a quarter or flat surface tool could also work).
OPERATION How to operate the handle: Right Cold water Left Hot water Close Close Open Open 6
REPLACEMENT PARTS No.
