PARTS SHEET KBF512** . Faucet Body . O-ring . Rubber Washer . Metal Washer . Mounting Nut . Mounting Screws Supply Lines 8. Aerator Wrench 9.
INSTALLATION GUIDE 1. Remove the mounting nut rubber washer (#3) and metal washer (#4) from the faucet body 2. Insert the main body into the hole with the o-ring the rubber washer metal washer (#4) and mounting nut (#5) from the faucet bottom.
INSTALLATION GUIDE 3. After adjusting the direction of the main body, tighten the mounting nut (#5) with hands and tighten the mounting screws (#6) with a Philips screwdriver. STEP 4 4. Connect the water lines to the supply valves tightly. Turn on the valves and check all connections at arrows for leaks. Re-tighten if necessary.
INSTALLATION GUIDE 5. From the top of the drain hole,place the drain @ through the installation hole. From under the drain hole, install the thick washer @,washer ® and nut @ by hand twisting on to the tail pipe of the drain. Then, install the tail pipe to the wall plumbing.Use of plumbers putty or silicone is recommended to seal drain ® to top side of bowl.
OPERATION How to operate the handle: Open 227 FT Close Left Right Hot water Cold water 1. Open the handle lever to turn water on. Push to turn off. 2. Turn the handle lever to the left to increase hot water flow with higher water temperature. Lower the water temperature by operating reversely.
