Instructions / Assembly

330 CENTRAL AVENUE, CLARK, NJ 07066
732-388-0300 • 800-526-4236 • FAX: [phone]
WEB: http://www.karnakcorp.com
Roofing
Roofing
41
Read Material Safety Data Sheets before using this product.
FM1010
over the damaged area, then embed Karnak Cotton, Glass or Poly-Mat
reinforcement and apply another coat of Karnak #19 Ultra Rubberized over the
entire patch. New asphalt roof surfaces should weather a minimum of 180 days
before be ing coated with Karnak #97 Ultra Rubberized Fibered Aluminum Roof
Coating. However, Karnak #97AF Fibered Aluminum Roof Coating can be coated
on roofs 3 to 5 days after Karnak asphalt emulsions have been applied. Badly
weathered or alligatored asphalt surfaces should be primed with Karnak 100AF
Non-Fibered Emulsion or 220AF Fibered Emulsion prior to coating with 97AF
Fibered Aluminum Roof Coating. Allow emulsion primer to cure a minimum of 3-5
days before application of aluminum coating.
NOTE:
Discoloration will occur in areas where Karnak #19 Ultra Rubberized Cement is not
allowed to dry a mini mum of 60 days.
APPLICATION:
Karnak #97AF Fibered Aluminum Roof Coating should be spread uniformly over
the roof surface. Care should be taken not to overwork the coating during
applica tion. This could have a damaging effect on the leafing of the aluminum.
Pour the correct amount of aluminum coating to cover a given area and work it in
one direction. Be sure to mechanically mix the aluminum coating thor oughly before
using. Karnak #97AF Fibered Aluminum Roof Coating can be ap plied with a soft
roof brush, roller or spray.
COVERAGE:
Apply at the rate of 1 to 1.5 gallons per 100 sq. ft.
CARE OF TOOLS:
Equipment may be thoroughly cleaned after use with mineral spirits, taking the
necessary precautions when handling combustible materials.
CAUTION:
Do not use near open flame. Avoid breathing solvent fumes and prolonged contact
with skin. Do not take internally. If swallowed, do not induce vomiting. Call a
physician immediately. Keep out of reach of children. Keep container covered when
not in use. Do not thin. Dispose of in an environmentally safe manner. Cover air
intakes during application and while drying.
97AF Fibered Aluminum Roof Coating
Patch and repair all seams, flashings,
cracks, leaks and damaged areas with appropriate materials.