SDS

Safety Data Sheet
502 RC-W Elasto-Kote
SDS Revision Date:
02/01/2020
Page 5 of 13
6. Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Put on appropriate personal protective equipment (see section 8).
6.2. Environmental precautions
Do not allow spills to enter drains or waterways.
Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet. Promptly remove
soiled clothing and wash thoroughly before reuse.
6.3. Methods and material for containment and cleaning up
Dike or contain spill with earth, floor dry, sand etc. Ventilate the area. Absorb spill with suitable absorbent material
and place in a closed container.
Keep product out of sewers and waterways by diking or impounding. Advise authorities if product has entered or may
enter sewers or waterways. Assure conformity with applicable governmental regulations.
7. Handling and storage
7.1. Precautions for safe handling
Vapors are heavier than air and may travel along the ground or be moved by ventilation to locations distant from the
point of material handling. To prevent from entering buildings or confined areas, close all air intake sources near the
material handling or the work area.
Avoid prolonged or repeated inhalation of vapors or spray mists. Avoid prolonged or repeated skin contact. Adhere to
good hygienic practices. Use with adequate ventilation.
Health studies have shown that many petroleum hydrocarbons pose potential human health risks which may Vary
from person to person. As a precaution, exposure to liquids, vapors, mists or fumes should be minimized.
See section 2 for further details. - [Prevention]:
7.2. Conditions for safe storage, including any incompatibilities
Handle containers carefully to prevent damage and spillage.
Incompatible materials: Strong Oxidizers
Store in a cool, dry place, out of direct sunlight and away from heat, sparks, and flame.
See section 2 for further details. - [Storage]:
7.3. Specific end use(s)
No data available.