SDS

Safety Data Sheet
19 Ultra, Asphalt Cements/Mastics/Coatings
SDS Revision Date:
03/19/2015
Page 5 of 13
Keep away from heat / sparks / open flames / hot surfaces - No smoking.
Keep cool.
Ground / bond container and receiving equipment.
Use explosion-proof electrical / ventilating / light / equipment.
Use only non-sparking tools.
Take precautionary measures against static discharge.
Avoid breathing dust / fume / gas / mist / vapors / spray.
Do not get in eyes, on skin, or on clothing.
5.3. Advice for fire-fighters
When heated above flash point, material will release flammable vapors which can burn or be explosive in confined
spaces if ignited. Do not mix with strong oxidants such as liquid chlorine or concentrated oxygen.
If the fire does not respond to above agents or they are not available, use foam or water FOG as a last resort. Water
may also be used to cool exposed, but not burning, containers. These products may float and be re-ignited on top of
water.
Closed containers may explode in a fire. Keep containers cool and remove to a safe location.
In a confined space, wear positive pressure, self-contained breathing apparatus, (SCBA) with a full face-piece and
protective clothing. Persons without respiratory protection should leave area.
ERG Guide No.
130
6. Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Put on appropriate personal protective equipment (see section 8).
6.2. Environmental precautions
Do not allow spills to enter drains or waterways.
Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet. Promptly remove
soiled clothing and wash thoroughly before reuse.
6.3. Methods and material for containment and cleaning up
Contain spill as quickly as possible. Keep flowing material away from heat, sparks, or open flames. Do not smoke
near a spill. Use clay (Oil Dry™), sand, earth, etc. to absorb the spill. Put material into a suitable steel drum which
can be closed securely.
Eliminate ignition sources. Soak up with noncombustible absorbent material. Remove absorbent material for proper
disposal.
7. Handling and storage
7.1. Precautions for safe handling
The requirements of the Highly Flammable Liquids and Liquefied Petroleum Gases Regulations apply if the flashpoint
is between 21°C and 32°C.
See section 2 for further details. - [Prevention]: