SDS

Safety Data Sheet
169 Aluminum Asphalt Coatings
SDS Revision Date:
05/01/2015
Page 5 of 12
Take precautionary measures against static discharge.
Do not breathe mist / vapors / spray.
Do not get in eyes, on skin, or on clothing.
5.3. Advice for fire-fighters
When heated above flash point, material will release flammable vapors which can burn or be explosive in confined
spaces if ignited. Do not mix with strong oxidants such as liquid chlorine or concentrated oxygen.
Minimize breathing vapors, gases or fumes of decomposition products. Do not enter any enclosed or confined fire
space without proper protective equipment, including self-contained breathing apparatus.
ERG Guide No.
130
6. Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Put on appropriate personal protective equipment (see section 8).
6.2. Environmental precautions
Do not allow spills to enter drains or waterways.
Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using toilet. Promptly remove
soiled clothing and wash thoroughly before reuse.
6.3. Methods and material for containment and cleaning up
Eliminate sources of ignition, and ventilate the area. Add sand or earth or absorb spill with suitable absorbent material
and place in a closed container.
Keep product out of sewers and waterways by diking or impounding. Advise authorities if product has entered or may
enter sewers or waterways. Assure conformity with applicable governmental regulations.
Eliminate ignition sources. Soak up with noncombustible absorbent material. Remove absorbent material for proper
disposal.
7. Handling and storage
7.1. Precautions for safe handling
The requirements of the Highly Flammable Liquids and Liquefied Petroleum Gases Regulations apply if the flashpoint
is between 21°C and 32°C.
See section 2 for further details. - [Prevention]:
7.2. Conditions for safe storage, including any incompatibilities
Handle containers carefully to prevent damage and spillage.
Naked flames and smoking should not be permitted in storage areas. It is recommended that fork lift trucks and
electrical equipment are protected to the appropriate standard.
Incompatible materials: Strong acids, alkalis, and oxidizers such as liquid chlorine, halogens, hydrogen peroxide,
oxygen.