Product Manual

17
4.4.2 Method of restraint
The Ergo Lite (KM-2501) was tested with four point webbing systems. Please refer
to the restraint manufacturer’s user guide for further details of its operation.
Fitting the front restraint
 Connect the straps around the wheelchair frame and caster bracket as pictured
below. The anchor point is marked with a yellow sticker.
 Take the brakes off and reverse the wheelchair to tension the front straps. Apply
wheelchair brakes (the brakes should be left on during transport)
Fitting the rear restraint
 Attach rear straps into rail approximately 11.8 in behind the wheelchair backrest.
 Attached the hooks to the rear frame of the wheelchair as pictured below.
Tension the restraint until the wheelchair is secure.
Fitting the front restraint Fitting the rear restraint
Fitting seat beat
 Fasten the 3 point safety belt around the user.
 The occupied wheelchair should be located in a forward-facing configuration,
with the parking brake applied.
 Pelvic restraints should make full contact across the front of the body near the
junction of the thigh and pelvic as pictured below (correct seat belt position).
 Restrains should not be held away from body by wheelchair components such as
armrest or wheels as pictured below (Incorrect seat belt position).
Correct seat belt position Incorrect seat belt position