Manual
20
b. Lightly lubricate all other areas, including the bore and the magazine well.
If the pistol has been exposed to salt water, dry it thoroughly, clean, and
lubricate as soon as possible.
Caution
Excessive oil could cause loss of control during firing.
c. Prior to loading the pistol, attention should be directed to wiping all
visible oil from the bore and exterior areas.
6-3. SAFETY CHECK TESTS. Whenever the Combat NCO™ .45 caliber Pistol is
reassembled, perform the below listed safety checks. If the safety checks perform as
indicated, the pistol is operationally ready. If the checks do not perform as indicated,
report the problem to the unit Armorer.
Warning
Make certain the pistol is cleared.
a. Manual Safety. With the hammer cocked and the weapon ON manual
safety and the hand grasping the grip safety, pull the trigger. If the hammer
does not fall the manual safety is working properly.
b. Grip Safety. With the hammer cocked and the weapon OFF manual safety
and the hand NOT grasping the grip safety, pull the trigger. If the hammer
does not fall the grip safety is working properly.
c. Half-cock Notch. Draw back the hammer until the sear engages the half-
cock notch and squeeze the trigger. If the hammer falls the sear or the
hammer must be replaced.
d. Disconnector. Cock the hammer. Shove the slide one–quarter inch to the
rear; hold slide in that position and squeeze the trigger. Let the slide go
forward maintaining pressure on the trigger. If the hammer falls, the
disconnector is worn and must be replaced.