Use and Care Manual

7. Place the table panel above the

side cabinet and the plate. Line up

the holes on the plates with those at

the bottom of the table panel. Take

out the screws and washers from the

bag. Attach the washers to the screws

and then fix the side cabinet and

plate to the table panel by tightening

the screws. (Tip: You can line up all

the holes on the table panel with

those on the plates and put the

screws in and tighten them slightly at

first. If some of the holes don’t line

up well, you can loosen the screws

and realign the holes. After all the

screws are put in and all the holes are

aligned well, you can fully tighten the

screws.)

8. To make sure that the side

container can be attached to the

plate holes securely, the back of the

container (the side that is close to

the panel after installation) should

be parallel to the ground when you

try to install it. (Please refer to the

picture.)

9. Push the drawers into the cabinet.

Place the wrist pad upon the table-

top. And clamp the LED lamp to the

table. Then the manicure table is

ready for use.

step7-8

step9

Manicure

Table Instruction

Thanks for your purchase. If you have any questions, please feel

free to contact us. We will resolve all your problem ASAP. And we

are glad to hear from your opinions and keep improving our

product and service. For more details, please contact us by email

via support@mefeir.com. (Please write your seller's Order # in the

email subject so that we can locate your order and better assist

you).

PAGE 1
7. Place the table panel above the side cabinet and the plate. Line up the holes on the plates with those at the bottom of the table panel. Take out the screws and washers from the bag. Attach the washers to the screws and then fix the side cabinet and plate to the table panel by tightening the screws. (Tip: You can line up all the holes on the table panel with those on the plates and put the screws in and tighten them slightly at first.
PAGE 2
◆ PARTS INVENTORY: 3. Loosen the screws on the cabinet door. Line up the holes on the door with the hinge on the plate. Put the screws in and tighten them. 4. Attach the washer to the wheel bolt. And then fasten the wheel bolt to the hole at the cabinet bottom by turning it clockwise. To tighten the wheel, you can use the tiny wrench provided or your own wrench that may fit. And your hands may work as well. You can turn the wheel with your hands at first and then turn it more tightly it with the wrench.