RY43-0009
• Table of Contents. ….........................................................................…2 • Warning and Cautions. ………..............................……........................3-5 • Tools and Parts.................................................................................6-9 • Lighting Operation..…….........……….......….........……….................. 10-11 • Maintenance and Sta 「·age...................….........................….......... 12-13 • TroL』 ble Shooting. …...............................
I WARNINGS AND CAUTIONS Read伽e ins剧。tions befo陪 use. This appliance must be installed in aα::ordance with nforced regulations and the following inst 阳ctions. 。 CAUTION Ins阳lier: Leave the manual with the user for仙ture use. Consumer: Pl”“比例p this manual for仙ture reference. 牟 ：：�： & WARNING 牟 o ：： di:r由酬� t� －耐ut衍 re � ！。t／�h�： ” Y 对口�I I副 … 阳 副I。 manual.
O AA BB DD B-1 B-2 C EE Table Top A Table Top B Back Panel L Left Leg CC FF 2 2 1 1 Lava Rocks P Q R AA BB CC DD EE FF Protective Cover Glass Clamp Glass Short Plank Glass Long Plank M6 x 16 Screw M6 x 35 Screw 8 2 2 4 20 24 1 M6 x 8 Screw M12 Screw 4 8
Attaching Fire Bowl 1. Insert the table top (B-2) and the fire bowl (G) using 8pcs M6 x 8 screws (EE) and 4 pcs washers (CC ) DD EE CC Attaching Table top 2. Insert the table top (B) using 8pcs M6 x 35 screws (BB) BB DD Checking the gas control 3. Put the control knob (M) on the valve stem. Check that the control knob for the gas supply system is turned to the "OFF"position before starting any assembly.
4. Attach the back panel (E) and front panel(D) to the side panel (F) using 4pcs M6 x35 screws (BB ) and 4 pcs washers (CC ) DD BB CC DD 5. Attach right front leg,left back leg,right back leg and left front leg to the metal stand (J)using 4 pcs M6 x 35 screws (BB) and 4 pcs washers (CC). BB CC J Att 6. Att M6 x 16 screws (AA (CC).
7.Place propane gas tank (not included)into the metal stand (J)Make sure the gas tank sits on the metal stand (J)completely. Turn the preassembled wingscrew on the outer part of metal stand(J) clockwise to secure the propane gastank tightly. 8.Turn the cylinder valve on the tank clockwise to close the propane tank. Attach the preassembled regulator from the table top (B) to the cylinder valve by turning the regulator coupling nut clockwise.
Assembly Assembling the glass Unscrew all preassembled screws on the glass clamps Then, assemble one glass panel to the other glass panel . Repeat for the rest two glass panels. Then, assemble the two glass panel pieces together with the final glass clamps as shown below. Inserting the glass Insert the glass assembly made in step 1 into the ridge on the top of the fire table body .
。 。 PERATI N & WARNING: Never u四 this appliance for oth叫an the intended use. Do 川四 this appliance to prepare food. 。 。 Initial Lighting: When lit for the first time, the appliance emits a slight odor. This is normal tempora叩c nditi n caused by the “burn 一in” of internal paints and lubricants used in the manufacturing process and d es not occur again. Simply run the main burner on high for approximately one-half hour.
