User Manual

Pro3&4_4.1

#1=

STEP 1

TRUCKs’

BEDRAIL

Front

Stake

Pocket

-nut

Bed Rail Clamp

FOOTPLA

(front)

Position FRONT FOOTPLATES on the truck bedrail, as far

forward as possible. Determine which pre-drilled hole (if any) falls over

the stake pocket. If none of the pre-drilled holes fall over the stake

pocket, mark and drill a hole in the foot plate that is approximately over

the center of the stake pocket. Put bolt T through FOOTPLATE and start T Nut Q

as shown. Maneuver

T Nut Q inside the stake pocket, push the FOOTPLATE forward

against the bulkhead, and tig

hten the T nut up against the underside of the

truck bed rail. Secure the rear of the front FOOTPLATE to the bedrail using

Bolt S and Bed Rail Clamp R as shown.

Note: If you prefer to mount the FOOTPLATES by drilling through the truck

bedrail, locate the FOOTPLATES as per above, and attach using included

fasteners D,K & M . We recommend using the pre-drilled hole at the rear

of the FOOTPLA

TES. You will have to locate and drill a second hole in the

FOOTPLATE, get as close to the leg as possible. Be sure you can access the nut.

TRUCK

CAB