Operation Manual

20 English
– other smooth surfaces
Î Perform a fat dissolving basic cleaning
using the manual nozzle (E1) and a ter-
ry cloth cover (E2) before the first clean-
ing using the window nozzle.
Î Apply steam to the glass surface from a
distance of approximately 20 cm until
the surface is moistened evenly.
Î Strip the glass surface in straight lines
from the top to the bottom using the rub-
ber lip of the window nozzle. Wipe the
rubber lip and the bottom edge of the
window dry after each strip.
Application:
– all washable wall and floor coverings,
e.g.: Stone floors, tiles, and PVC floors.
Î Attach the floor cloth to the floor nozzle.
1 Fold the floor cloth the long way and
place the floor nozzle on top of it.
2 Open holding clamps.
3 Place the cloth ends into the openings.
4 Close the holding clamps.
Caution
Do not insert fingers between the clamps.
Figure 4
Î To remove the cloth, press the retaining
clips (H2), and pull out the cloth.
Î Turn and exchange the floorcloth in reg-
ular intervals. Thus, you improve the
ability to pick up dirt.
Î Work slowly on very dirty surfaces to al-
low the steam to act on the dirt for a
longer period of time.
Î If there are residues of detergents or
floor cleaning products (e.g. wax, liquid
polish) on the surface to be cleaned,
streaks may form during the cleaning.
These streaks normally disappear after
a repeated use of the steam cleaner.
Set of micro-fibre dusters "Bath“
(order no. 2.863-171)
- 2 soft bath towels made of plush velours.
- 1 Abrasive cover for hand nozzle.
- 1 polishing cloth for mirror and bathroom
fittings
Set of micro-fibre dusters "Kitchen“
(order no. 2.863-172)
- 2 soft floor towels made of plush velours.
- 1 soft cover for hand nozzle made of plush
velours.
-1 cloth for streak-free cleaning of stainless
steel sufaces.
Set of micro-fibre dusters for floor nozzle
(Order no. 2.863-173) - 2 soft floor towels
made of plush velours.
Set of micro-fibre dusters for hand nozzle
(order no. 2.863-174)
-1 soft cover made of plush velours.
Round brush kit (order no. 2.863-058)
4 round brushes for the detail nozzle.
Round brush kit with brass bristles
(order no. 2.863-061)
3 round brushes for the detail nozzle (for
particularly stubborn dirt)
Terry cloths (order no. 6.369-357)
- 5 floorcloths
Terry covers (order no.6.3710-990)
- 5 covers
Decalcifier sticks
(order no. 6.295-206)
Round brush with scraper
(order no. 2.863-140)
Window nozzle (order no. 4.862-115)
Rubber lip for window nozzle
(order no. 6.273-140)
Steam turbo-brush
(order no. 2.863-159)
Extension (order no. 5.762-236)
Detail nozzle extension
Power nozzle (order no. 5.762-326)
Detail nozzle attachment
Floor nozzle (H1)
Special accessories