5.
CONTENTS IMPORTANT SAFETY INSTRUCTIONS ................ 4 1. Starting .............................................................. 6 2. Operation ........................................................... 8 3. Care and Maintenance ...................................... 9 4. Troubleshooting ................................................. 9 5. General Information ......................................... 10 6. Technical Data ................................................. 10 7. Spare Parts.............
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS ! Please read these operating instrucions before starting and strictly observe the “Safety Instructions for High Pressure Cleaners (5.951-949)”. WARNING When using this product basic precautions should always be followed, including the following: • Read all the instructions before using the product. • To reduce the risk of injury, close supervision is necessary when a product is used near children.
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS ! CAUTION Water Supply • Water hose must be at least 1/2 inch in diameter. • The flow rate of the water supply must not fall below 2.5 GPM (gallons per minute). • Flow rate can be determined by running the water for one minute into an empty 5-gallon container. • Water can also be drawn from a standing water supply such as a lake or a drum by means of filtered suction hose (optional accessory). • The water supply temperature must not exceed 104 °F.
1.
1. Starting Electrical Connection 1 Appliance switch (ON/OFF) 2 High-pressure outlet 3 Carrying handle • See technical data of connected values. • Check whether the voltage shown on the rating plate corresponds to that of the power source. 4 Connection lead 5 Coupling 6 Water connection with filter Water Connection 7 Trigger gun with safety ratchet (A) and high-pressure hose • See technical data for connected values.
2. Operation Operation with High-pressure Interrupting Operation • Connect the spray wand with the spray wand • In the event of extended work breaks (more than extension. • Release the gun trigger with the safety ratchet 5 minutes), switch off the pump to avoid damage due to water overheating. and pull the trigger. • Switch on the appliance. • You can choose between different types of spray by rotating the front protective device on the vario nozzle.
3. Care and Maintenance Monthly or as Required Sub-zero Temperature Protection • Clean the nozzle. • Frost will destroy an appliance which has not Remove dirt from the nozzle hole with a needle, and rinse with water from the front. been completely emptied of water. Ideally, the appliance shold be stored in a frost-free room. • Clean the strainer in the water connection. It can be easily removed with a flat-nosed pliers. 4.
5. General Information Safety Equipment Warranty Safety Valve/Overflow valve The applicable warranty conditions in different countries are issued by the respective national distributor of KÄRCHER products. During the warranty period, any malfunctions of the unit caused by a material or manufacturing defect will be repaired free of charge. In the event of a warranty claim, please take the unit, with proof of purchase, to your original dealer, or to the nearest authorised customer service centre.
Notes 11
