Operating instructions

- 8
 Loosen the fastening screws of the
sealing strip.
 Adjust or replace sealing strip.
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 0-10 mm.
 Tighten the fastening of the sealing
strip.
 Side sealing strips
 Loosen the fastening screws of the
sealing strip.
 Adjust or replace sealing strip.
 To set the floor clearance, insert a
sheet with a thickness of max. 2 mm un-
der the sealing strip.
 Adjust sealing strip.
 Tighten the fastening of the sealing
strip.
몇 WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Lock parking brake.
 Shake off dust filter.
 Open the locking screw of the dust filter
cover in an anticlockwise direction.
 Lift the dust filter cover.
 Replace dust filter Make sure the dust
filter is inserted correctly (see figure).
 Screw in the locking screw all the way.
CAUTION
If the locking screw is not tightened all the
way, there may be damages.
Note: Make sure when installing the new
filter that the fins are not damaged.
 KM 75/40 W Bp
1 Fuse F1 (50 A)
2 Fuse F2 (2 A)
3 Relay
4 Battery charge plug
 Open the device hood.
 Replace defective fuse or relay.
 KM 75/40 W Bp Pack
The fuses are located in the charger.
We hereby declare that the machine de-
scribed below complies with the relevant
basic safety and health requirements of the
EU Directives, both in its basic design and
construction as well as in the version put
into circulation by us. This declaration shall
cease to be valid if the machine is modified
without our prior approval.
The signatories act on behalf of and with
the authority of the company management.
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Straße 28-40
71364 Winnenden (Germany)
Tel.: [phone]
Fax: [phone]
Winnenden, 2020/01/01
Replacing dust filter
Replace fuse/ relay
Accessories
Side-brushes, soft 6.905-626.0
For fine dust on inside surfaces; wetness
resistant.
Roller-brush, soft 6.906-886.0
With natural bristles: especially for sweep-
ing fine dust on smooth floors indoors.
Not resistant to wetness; do not use on
abrasive surfaces!
Roller-brush, hard 6.906-885.0
For removing stubborn dirt in the external
area; resistant to moisture.
Roller brush, antistatic 6.906-950.0
For statically chargeable surfaces such as
carpet or artificial turf
Carpet sweeping unit 2.641-571.0
Includes: Lint trap, antistatic roller brush,
triple steering roller
EU Declaration of Conformity
Product: Vacuum sweeper
Type: 1.049-xxx
Relevant EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2000/14/EC
Applied harmonized standards
EN 55012: 2007 + A1: 2009
EN 60335–1
EN 60335–2–72
EN 61000–6–2: 2005
EN 62233: 2008
Applied national standards
---
Applied conformity evaluation method
2000/14/EC: Appendix V
Sound power level dB(A)
Measured: 83
Guaranteed: 86
Chairman of the Board of Management
Director Regulatory Affairs & Certification
19EN