Safety data sheet

Page 5/10
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 03.12.2021 Revision: 13.11.2019Version number 4 (replaces version 1)
Trade name:
SurfacePro Surface Cleaner CA 30 C eco!perform
(Contd. of page 4)
53.2.5
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact gloves made of the following materials are suitable:
* butyl rubber 0,7 mm, 480 min (EN 374)
·
As protection from splashes gloves made of the following materials are suitable:
* nitril rubber 0,4 mm, 30 min (EN 374)
·
Eye/face protection
Goggles recommended during refilling.
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Physical state
Fluid
·
Colour:
Blue
·
Odour:
Fruit-like
·
Odour threshold:
Not determined.
·
Melting point/freezing point:
-3 °C
·
Boiling point or initial boiling point and boiling
range
100 °C
·
Flammability
Not applicable.
·
Lower and upper explosion limit
·
Lower:
Not determined.
·
Upper:
Not determined.
·
Flash point:
54 °C (Closed Cup)
Does not support burning
·
Auto-ignition temperature:
Product is not selfigniting.
·
Decomposition temperature:
Not determined.
·
pH at 20 °C
11.2
·
pH 1 % dem.
9.5
·
Viscosity:
·
Kinematic viscosity
Not determined.
·
dynamic at 20 °C:
3 mPas
·
Solubility
·
Water:
Fully miscible
·
Partition coefficient n-octanol/water (log value)
Not determined.
·
Vapour pressure:
Not determined.
·
Density and/or relative density
·
Density at 20 °C:
1 g/cm³
·
Relative density
Not determined.
·
Vapour density
Not determined.
·
9.2 Other information
·
Appearance:
·
Form:
Fluid
(Contd. on page 6)
EU