Safety data sheet

Page 4/8
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 12.02.2021 Revision: 20.09.2019Version number 2
Trade name:
FloorPro Fine Stoneware Cleaner RM 753
(Contd. of page 3)
52.0.1.1
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact gloves made of the following materials are suitable:
* butyl rubber 0,7 mm, 480 min (EN 374)
·
As protection from splashes gloves made of the following materials are suitable:
* nitril rubber 0,4 mm, 30 min (EN 374)
·
Eye/face protection
Goggles recommended during refilling.
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Physical state
Fluid
·
Colour:
Yellow
·
Odour:
Product specific
·
Odour threshold:
Not determined.
·
Melting point/freezing point:
0 °C
·
Boiling point or initial boiling point and boiling
range
100 °C
·
Flammability
Not applicable.
·
Lower and upper explosion limit
·
Lower:
Not determined.
·
Upper:
Not determined.
·
Flash point:
Not applicable
·
Auto-ignition temperature:
Product is not selfigniting.
·
Decomposition temperature:
Not determined.
·
pH at 20 °C
10.5
·
pH-value 1 %:
8.7
·
Viscosity:
·
Kinematic viscosity
Not determined.
·
dynamic at 20 °C:
4 mPas
·
Solubility
·
Water:
Fully miscible
·
Partition coefficient n-octanol/water (log value)
Not determined.
·
Vapour pressure at 20 °C:
23 hPa
·
Density and/or relative density
·
Density at 20 °C:
1.133 g/cm³
·
Relative density
Not determined.
·
Vapour density
Not determined.
(Contd. on page 5)
EU