Safety data sheet

Page 4/9
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 12.02.2021 Revision: 20.09.2019Version number 2
Trade name:
FloorPro Fine Stoneware Cleaner RM 753
(Contd. of page 3)
52.0.1.1
SECTION 8: Exposure controls/personal protection
·
8.1 Control parameters
·
Ingredients with limit values that require monitoring at the workplace:
57-55-6 Propylene glycol
WEL Long-term value: 474* 10** mg/m³, 150* ppm
*total vapour and particulates **particulates
·
8.2 Exposure controls
·
Appropriate engineering controls
No further data; see item 7.
·
Individual protection measures, such as personal protective equipment
·
General protective and hygienic measures
The usual precautionary measures are to be adhered to when handling chemicals.
·
Respiratory protection:
Not necessary if room is well-ventilated.
·
Hand protection
* chemical resistant protective gloves (EN 374)
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
For the permanent contact gloves made of the following materials are suitable:
* butyl rubber 0,7 mm, 480 min (EN 374)
·
As protection from splashes gloves made of the following materials are suitable:
* nitril rubber 0,4 mm, 30 min (EN 374)
·
Eye/face protection
Goggles recommended during refilling.
*
SECTION 9: Physical and chemical properties
·
9.1 Information on basic physical and chemical properties
·
General Information
·
Physical state
Fluid
·
Colour:
Yellow
·
Odour:
Product specific
·
Odour threshold:
Not determined.
·
Melting point/freezing point:
0 °C
·
Boiling point or initial boiling point and boiling
range
100 °C
·
Flammability
Not applicable.
(Contd. on page 5)
GB