Product Manual

English 9
Fasten the T-Racer directly to the high-
pressure gun.
1 Press the bayonet connection of the T-
Racer into the connection of the high-
pressure gun.
2 Turn it by 90° until it locks into place.
3 Tighten the safety cover.
Caution
 Illustration
Always hold the T-Racer at the handle
while cleaning the walls.
 Adjust the turning handle "power" as
per the surface to be cleaned
 Slide the slide controller Hoovercraft ef-
fect all the way to the right.
The turning handle "power" is used to
change the distance of the high-pressure
nozzles to the surface to be cleaned.
Robust surfaces (for e.g. tiles, concrete,
stone)
 Illustration
Set turning handle "power" to "MAX".
For the effective cleaning of hard-to-re-
move contamination.
Sensitive surfaces (for e.g. wood)
 Illustration
Set turning handle "power" to "MIN".
For the gentle cleaning of sensitive sur-
faces.
Use the slide controller to open and close
the ventilation slots in the T-Racer casing.
This regulates the Hoovercraft effect.
 Illustration
Move the slide controller to the right.
The Hoovercraft effect decreases until
the T-Racer touches the floor.
 Illustration
Move the slide controller to the left.
The Hoovercraft effect increases until
the T-Racer hovers above the floor.
You can use the extension pipes with any
other Kärcher accessory.
High-pressure cleaner does not build up
the pressure or is vibrating.
 Dismantle the high-pressure nozzles,
check the high-pressure nozzles for
damage, rinse the T-Racer with clean
water then reinstall the high-pressure
nozzles.
Cleaning wall surfaces
Control elements
"Power" turning handle
Slide controller Hoovercraft effect
Tip
Troubleshooting