B 60 001 59645740 01/20
B 60 W Bp B 60 W Bp Dose B 60 W Bp Fleet B 60 W Bp Dose Fleet 2
Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. Contents Safety instructions . . . . . . . . . . Function. . . . . . . . . . . . . . . . . . Proper use . . . . . . . . . . . . . . . . Environmental protection. . . . . Warranty . . . . . . . . . . . . . . . . . Operating and Functional Elements. . . . . . . . . . . . . . . . . . . . Before Startup . . . . . . . . . . . . . Operation. . . . . . . . . .
Operating and Functional Elements 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 4 Vacuum bar lowering lever Cover waste water tank Holding rail for home base Protective turbine strainer (under the float) Wastewater reservoir rinsing system (option) Flexible lock of rinsing system (option) Lock of waste water tank Float Push handle Coarse dirt sieve Waste water tank Fresh water reservoir filler neck Suction hose for detergent (only DOSE model) Detergent bottle (only DOSE model) Lock of the f
Program selection switch 1 2 3 4 5 6 7 OFF Device is switched off Transport mode Driving to the Place of Use. Eco!efficiency mode Wet clean the floor (with reduced brush speed) and vacuum up wastewater (with reduced suction). Normal mode Wet clean the floor and vacuum up dirt water. Intense mode Wet clean the floor and allow the detergent to react. Vacuum mode Suck in the dirt fleet. Polishing mode Polishing the floor without the application of liquid.
Operation DANGER Risk of injury. Push the pedal for raising/ lowering the cleaning head with one foot only. The other foot must firmly be placed on the floor. In dangerous situations, release the safety switch/drive lever. Driving ATTENTION Risk of damage. The suction bar must be lifted for reversing. Note: The device is designed and built in such a way that the cleaning head protrudes towards the right. This enables working in a comfortable way close to the edges. Plug in the Intelligent Key.
Adjusting the brush contact pressure Arrest the lever in the desired position. Upper position: higher contact pressure Lower position: reduced contact pressure Lower the vacuum bar Pull the lever out and press it down; the vacuum bar is lowered. Note: – For cleaning tiled floors, adjust the straight suction bar in such a way that cleaning is not done at an angle of 90 degrees to the joints.
Storage 몇 CAUTION Risk of personal injury or damage! Consider the weight of the appliance when storing it. This appliance must only be stored in interior rooms. Care and maintenance DANGER Risk of injury! Before working on the appliance, remove the Intelligent Key and the mains plug of the charger. Drain and dispose of the dirt water and the residual fresh water. Maintenance schedule Maintenance intervals Recommended cleaning processes are shown on the display at certain cleaning intervals.
Insert the linch pin through the locking pins and fold the locking rings forward. Clean water distribution channel Remove the rubber strip and clean the channel with a cloth. After cleaning, replace the rubber strip evenly. 1 2 3 4 5 Replacing the brush rollers Lift the cleaning head. Loosen the lock of the wiper flap. Push the bearing lid down and remove. Pull out the brush roller. Note: The brush rollers must be replaced when the bristle length has reached 10 mm.
DANGER Risk of explosion. Do not place tools or the like on the battery, i.e. on the terminal poles and cell connectors. Risk of injury. Ensure that wounds never come into contact with lead. Always clean your hands after having worked with batteries. Recommended batteries, B 60 Order No. Description 6.654-141.01) 105 Ah - mainte12 V* nance-free 6 V** 6.654-242.02) 170 Ah - maintenance-free 6 V** 6.654-124.03) 180 Ah - maintenance-free 6.654-086.
Faults DANGER Risk of injury! Before working on the appliance, remove the Intelligent Key and the mains plug of the charger. Drain and dispose of the dirt water and the residual fresh water. Faults with display Display Remedy ERR_I_BÜRSTE_049 Check if foreign matters block the brushes; remove foreign matter if required. ERR_I_TURB_050 Check suction turbine for contamination and clean it if necessary. ERR_U_BATT_001 Check battery; charge it if required.
Accessory B 60 Part no.: Working width 550 mm Brush roller, red (medium, standard) 6.906-934.0 6.906-935.0 Brush roller, white (soft) Brush roller, orange (high/ low) 6.906-977.0 6.906-981.0 6.906-978.0 6.906-982.0 Brush roller, green (hard) Brush roller, black (very hard) 6.906-979.0 6.906-983.0 6.906-980.0 6.906-984.0 Pad roller shaft Roller pad, yellow (soft) 4.762-432.0 4.762-433.0 6.369-454.0 6.369-454.0 Also for regular cleaning of heavily dirtied floors.
Technical specifications BR appliance BD appliance B 60 B 60 R 55 R 65 D 55 D 65 Power Nominal voltage Battery capacity Average power consumption Drive motor output (rated output) Suction engine output Brush engine output Vacuuming Vacuum power, air volume (max.) Vacuuming power, negative pressure (max.) Cleaning brushes Brush speed Dimensions and weights Theoretical surface cleaning performance Max. working range incline Fresh/waste water tank volume Max. water temperature max.
