Owner's Manual

– 6
Get the electrical components checked and
repaired only by authorised customer serv-
ice persons.
Contact an authorised customer service
person in case of problems not mentioned
in this chapter or if you are in doubt or when
you have been explicitly asked to do so.
Plug in the main plug.
Check facility fuse.
Reset the suction turbine fuse on the
control panel.
Clean the vacuum bar.
Check, clean or replace the seal on the
dome.
Empty the dirt water reservoir.
Insert the suction hose properly on the
dome.
Check the suction hose for damages.
Set the appliance switch to normal op-
eration.
Fill the fresh water tank with hot water
(max. 60°C) and rinse the nozzle. Re-
place the nozzle as applicable (see
"Maintenance task/replace nozzle").
Fill up fresh water reservoir.
Clean the sieve in the fresh water reser-
voir.
Set the appliance switch to normal op-
eration.
Reset the brush drive fuse on the con-
trol panel.
Check the drive belt, replace if required.
Replace the worn nozzle with a new
one (see "Maintenance task/replace
nozzle").
Appliance is not working
Suction turbine does not run
Insufficient vacuum performance
No water exiting from nozzle
Brush does not turn
Carpet gets too wet
Technical specifications
Power
Nominal voltage V/Hz 220...240
/ 1~50
Type of protection IPX4
Average power con-
sumption
W 1300
Suction engine out-
put
W 1130
Brush engine output W 76
Cleaning brushes
Working width mm 260
Brush diameter mm 65
Brush speed 1/min 1650
Detergent pump
pressure
MPa 0,4
Detergent pump flow
rate
I/min 1,4
Max. water tempera-
ture
°C 60
Vacuuming
Cleaning power, air
quantity
l/s 46
Cleaning power, neg-
ative pressure
kPa 30,2
Dimensions and weights
Theoretical surface
cleaning perform-
ance
m²/h 100
Fresh/dirt water res-
ervoir volume
l 15/17
Length mm 920
Width mm 360
Height mm 750
Typical operating
weight
kg 52
Noise emission
Sound pressure level
(EN 60704-1)
dB(A)
77
Machine vibrations
Vibration total value
(ISO 5349)
m/s² 1,7
15EN