Operating instructions

– 7
1 Dosage cleaning solution
2 Switch for detergent solution
3 Control lamp to apply detergent so-
lution
4 Indicator lamp vacuuming
Green: Suction turbine in operation
Orange, flashing: Suction turbine over-
loaded
5 Indicator lamp brush drive
Green: Brush is rotating
Orange, flashing: Brush overloaded
6 Battery status display
Green Battery charged
Orange: Battery almost empty
Red Appliance swithces off: Load battery
7 Indicator lamp Eco mode
8 Switch Eco mode
9 Power switch
NOTICE
The device is equipped with a safety
mechanism to prevent total discharge,
i.e. when the permissible minimum ca-
pacity is reached, the machine will be
shut off.
The charging process takes approx. 3
hours.
The charger automatically switches off
the charging process.
If necessary, the appliance can be
used again before the battery has been
fully charged.
 Insert the mains plug into the socket.
1 Battery is charged (green)
2 Battery is being charged (yellow,
flashing)
3 Malfunction (red)
 Release the star knob for the trans-
port position.
 Straighten the steering column.
 Tighten the star handle.
몇 Warning
Risk of damage. Only use the recom-
mended detergents. With respect to
different detergents the operator bears
the increased risk regarding the opera-
tional safety and danger of accident.
Only use detergents that are free from
solvents, hydrochloric acid and hydro-
fluoric acid.
Follow the safety instructions for using
detergents.
Note
Do not use highly foaming detergents.
Observe the dosing notes.
 Swivel up the carrying handle of the
waste water tank.
Before Startup
Charging battery
Battery charging display
Operation
Filling in detergents
9EN