Operating instructions

– 9
The appliance can be equipped with vari-
ous accessories depending on the cleaning
task. Please request our catalogue or visit
us on the Internet at www.kaercher.com.
Insufficient cleaning
result
Check the brush type and the detergent for their suitability.
Check the brushes for wear, replace if required.
Brush does not turn Pull the safety switch towards the steering wheel.
Check the brush for blockage by foreign objects; remove the foreign
objects.
Switch off the switch for the brush drive, wait for a short period of
time, switch the switch back on.
Fault Remedy
Accessories
Description Part no.: Description
Disk brush, white 6.907-154.0 For polishing and cleaning sensitive floors.
Disk brush, red (medium,
standard)
6.907-151.0 For cleaning slightly dirtied or sensitive floors.
Disk brush, black (hard) 6.907-152.0 For cleaning heavily dirtied floors.
Disk brush, natural (white) 6.907-153.0 For polishing floors.
Pad driving disk 6.907-150.0 For intake of pads.
Pad, microfibre 6.905-060.0 Especially suited for the cleaning of linoleum
and fine stone tiles.
Pad, black 6.369-001.0 Deep cleaning of PVC, vinyl, synthetic resin
coatings, dark marble, granite, terrazzo,
ground smooth.
Pad, green 6.369-002.0 Maintenance cleaning of all water-resistant
floors.
Pad, red 6.369-003.0 Deep cleaning of linoleum, tiles, clinker,
glazed, stoneware.
Diamond pad, white 6.371-250.0 For polishing floors.
Diamond pad, yellow 6.371-251.0 For removing fine scrapes.
Diamond pad, green 6.371-235.0 For cleaning heavily dirtied floors.
Fill hose 6.680-124.0 For filling the fresh water tank
Suction lip kit 4.037-059.0 As replacement
Vacuum bar 4.037-067.0 As replacement
Technical specifications
Power
Nominal voltage V 25,9
Battery capacity Ah
(5h)
22
Battery type Li-ion
Average power con-
sumption
W 500
Suction engine output W 280
Brush engine output W 260
Operating temperature
range
°C 0...40
Vacuuming
Cleaning power, air
quantity
l/s 20
Cleaning power, nega-
tive pressure
kPa 8
Cleaning brushes
Working width mm 380
Brush diameter mm 380
11EN