Operating instructions
Operation and Safety Guide
Hard Surface Cleaner
Model # BR 40/10 C
On Your Apron as Karcher North America
Tool Tips & Safety Guide BR 40/10 C 8.644-845.0 - A 03/05/21
Page 4 of 4
Tool Operation:
Emptying the Dirty Reservoi
r
Note: If the dirt water reservoir is full, the flow closes
the suction channel. The suction operation is
interrupted. Empty the dirty water reservoir.
WARNING
Please observe the local provisions regarding the
wastewater treatment.
A. Remove the fresh water reservoir from the
appliance.
B. Lift up the wastewater reservoir and carry into
the disposal site.
Pour out dirty water. Rinse the dirty water tank
with clear water.
Shutting Down the Appliance
A. Release the switch for detergent solution.
Push the appliance forward for another 1-2
minutes to draw off residual water.
Release the brush drive button.
B. Press the pedal to lower the vacuum bar.
C. Place the slider vertically - the brushes are
elevated.
D. Pull out the mains plug.
CAUTION
Danger of Deforming the Brushes: When switching off
the appliance, take the load off the appliance by
placing the slider vertically.
Empting the Freshwater Tank
WARNING
Please observe the local provisions regarding the
wastewater treatment.
A. Open locks for the freshwater reservoir.
B. Tilt the carrying handle for the wastewater
reservoir towards the side.
Lift up the fresh water reservoir and carry it to
the disposal site.
C. Remove the cover of the freshwater reservoir
and pour out the liquid via the notch.
Rinse fresh water tank with clear water.
A
B
C
A
B
C
A
B
1
3
2
Finish Operation
D