Operating instructions

10 English
Description of the device
The maximum amount of equipment is described in
these operating instructions. Depending on the model
used, there are differences in the scope of delivery (see
packaging).
For the illustrations, refer to the graphics page
Illustration A
1 Device socket with cover
2 Water reservoir
3 Filling hole, water reservoir
4 Switch - On
5 Switch - Off
6 Indicator light (green) - heating
7 Indicator light (red) - water shortage
8 Carrying handle
9 Holder for accessories
10 Holder for accessories
11 Maintenance lock
12 Mains connection cable storage compartment
13 Park bracket for floor nozzle
14 Mains connection cable with mains plug
15 Non-driven wheels (2 x)
16 Steering roller
17 Steam gun
18 Steam lever
19 Unlocking button
20 Selector switch for steam volume (with child lock)
21 Steam hose
22 Steam connector
23 Spotlight nozzle
24 Round brush (small)
25 Power nozzle
26 Round brush (large)
27 Manual nozzle
28 Manual nozzle microfibre cover
29 Extension tubes (2 x)
30 Unlocking button
31 Floor nozzle
32 Hook and loop fastener
33 **Microfibre floor cloth (1 x)
34 Microfibre floor cloth (2 x)
35 Carpet glider
36 Descaler
37 **Steam pressure iron
38 Indicator light (orange) - heating
39 Steam switch (bottom)
40 Steam connector
** optional
Installation
Installing accessories
1. Insert and engage the steering roller and non-driven
wheels.
Illustration B
2. Open the cover on the device socket.
Illustration E
3. Connect the steam connector to the device socket
so that the steam connector audibly engages.
Illustration E
4. Push the open end of the accessory onto the steam
gun so that the unlocking button on the steam gun
engages.
Illustration J
5. Push the open end of the accessory onto the spot-
light nozzle.
Illustration K
6. Connect the extension tubes with the steam gun.
a Push the first extension tube onto the steam gun
so that the unlocking button on the steam gun en-
gages.
The connection pipe is connected.
b Push the second extension tube onto the
first extension tube.
The connection pipes are connected.
Illustration L
7. Push the accessory and / or the floor nozzle onto the
free end of the extension tube.
Illustration M
The accessory is connected.
Disconnecting accessories
1. Set the selector switch for the steam volume to the
rear.
The steam lever is locked.
2. Push the cover on the device socket down and discon-
nect the steam connector from the device socket.
3. Push the unlocking button and pull the parts apart.
Illustration R
Operation
Filling water
The water reservoir can be removed at any time for fill-
ing or be filled directly at the device.
ATTENTION
Damage to the device
Unsuitable water can block the nozzles or damage the
water level indicator.
Do not fill in pure distilled water. Use a maximum of 50%
distilled water mixed with tap water.
Do not use condensation from the clothes dryer for filling.
Do not use collected rain water for filling.
Do not use cleaning agents or other additives (e.g.
scents) for filling.
Remove the water reservoir for filling
1. Pull the water reservoir vertically upwards.
Illustration C
2. Fill the water tank vertically with tap water or a mix-
ture of tap water and no more than 50% distilled wa-
ter up to the "MAX" mark.
3. Insert the water reservoir and press downwards until
it locks into place.