Operating instructions
Table Of Contents
- English
- Contents
- Information about the vehicle
- Safety instructions
- 3.1 Notes on unloading/unpacking
- 3.2 General notes on safety
- 3.3 Work clothing
- 3.4 Safety instructions concerning the operation
- 3.5 Safety information concerning the driving operation
- 3.6 Safety guidelines for LPG vehicles (only gas engine)
- 3.7 Safety information concerning the combustion engine
- 3.8 Safety information concerning the transport of the vehicle
- 3.9 Safety information concerning maintenance and care
- 3.10 Safety Devices
- Overview of the appliance
- Start up
- Operation
- Transport
- Storage/decommissioning
- Care and maintenance
- 9.1 General notes
- 9.2 Cowlings
- 9.3 Battery
- 9.4 Maintenance intervals
- 9.5 Inspection and maintenance work
- 9.5.1 General notes on safety
- 9.5.2 Secure raised waste container
- 9.5.3 Check engine oil level and top up, if required
- 9.5.4 Change the motor oil and the oil filter
- 9.5.5 Check brake fluid status
- 9.5.6 Check hydraulic oil level and refill oil
- 9.5.7 Replacing the hydraulic oil filter
- 9.5.8 Checking the coolant level and topping up coolant
- 9.5.9 Cleaning and replacing the air filter
- 9.5.10 Greasing the vehicle
- 9.6 Replacing brushes
- 9.7 Replacing side brushes
- 9.8 Cleaning
- 9.8.1 Cleaning/replacing dust filter cartridges
- 9.8.2 Cleaning/replacing the flat fold filter
- 9.8.3 Cleaning the vehicle
- 9.8.4 Clean the waste water tank
- 9.8.5 Clean the fresh water reservoir
- 9.8.6 Cleaning sealing lips, suction bar and spray nozzles
- 9.8.7 Clean the waste container
- 9.8.8 Clean water filter.
- 9.8.9 Clean the hydraulic oil cooler and the radiator
- 9.9 Replacement tasks
- 9.10 Accessories
- Troubleshooting
- Specifications
- Français
- Table des matières
- Indications relatives au véhicule
- Consignes de sécurité
- 3.1 Instructions pour le déchargement/ déballage
- 3.2 Consignes de sécurité générales
- 3.3 Vêtements de travail
- 3.4 Consignes de sécurité relatives à la commande
- 3.5 Consignes de sécurité relatives au mode de déplacement
- 3.6 Respecter les directives de sécurité technique pour les véhicules à gaz liquéfié (seulement moteur à gaz).
- 3.7 Consignes de sécurité relatives au moteur à combustion
- 3.8 Consignes de sécurité relatives au transport du véhicule
- 3.9 Consignes de sécurité relatives à l'entretien et à la maintenance
- 3.10 Dispositifs de sécurité
- Aperçu de l'appareil
- Mise en service
- Fonctionnement
- 6.1 Condition de roulage
- 6.2 Nettoyage au mouillé
- 6.3 Balayer
- 6.4 Mettre l'appareil hors tension
- Transport
- Stockage / arrêt
- Entretien et maintenance
- 9.1 Consignes générales
- 9.2 Habillages
- 9.3 Batterie
- 9.4 Consignes de sécurité
- 9.5 Fréquence de maintenance
- 9.6 Travaux de contrôle et de maintenance
- 9.6.1 Consignes de sécurité générales
- 9.6.2 Sécuriser la cuve à poussière en position soulevée
- 9.6.3 Vérification du niveau d'huile moteur et rajout
- 9.6.4 Changer huile de moteur et le filtre d'huile de moteur
- 9.6.5 Contrôler le niveau de liquide de frein
- 9.6.6 Contrôler le niveau d'huile hydraulique et ajouter de l'huile
- 9.6.7 Remplacer le filtre à huile hydraulique.
- 9.6.8 Vérifier le niveau de liquide de refroidissement et ajouter du liquide de refroidissement
- 9.6.9 Nettoyage et échange du filtre à air
- 9.6.10 Lubrifier le véhicule
- 9.7 Remplacer les brosses
- 9.8 Remplacer les balais latéraux
- 9.9 Nettoyage
- 9.9.1 Nettoyer / remplacer les cartouches de filtre à poussières
- 9.9.2 Nettoyer / remplacer le filtre plat plissé
- 9.9.3 Nettoyer le véhicule
- 9.9.4 Nettoyage du bac d'eau sale
- 9.9.5 Nettoyer le réservoir d'eau propre
- 9.9.6 Nettoyer les lèvres d'étanchéité, la barre d'aspiration et les buses de pulvérisation
- 9.9.7 Nettoyer la cuve à poussière
- 9.9.8 Nettoyer le filtre à eau
- 9.9.9 Nettoyer le refroidisseur d'huile hydraulique et le radiateur du moteur.
- 9.10 Travaux de remplacement
- 9.11 Accessoires
- Service de dépannage
- Caractéristiques techniques
- Español
- Índice de contenidos
- Indicaciones sobre el vehículo
- Indicaciones de seguridad
- 3.1 Indicaciones para la descarga/ desembalaje
- 3.2 Indicaciones generales de seguridad
- 3.3 Ropa de trabajo
- 3.4 Indicaciones de seguridad para el manejo
- 3.5 Indicaciones de seguridad para el modo de desplazamiento
- 3.6 Observe las directivas de seguridad para vehículos a gas licuado (solo motor de gas)
- 3.7 Indicaciones de seguridad para el motor de combustión
- 3.8 Indicaciones de seguridad para el transporte del vehículo
- 3.9 Indicaciones de seguridad para cuidar y mantener
- 3.10 Dispositivos de seguridad
- Vista general del aparato
- Puesta en marcha
- Funcionamiento
- 6.1 Manejo
- 6.2 Limpieza en húmedo
- 6.3 Barrido
- 6.4 Parar el aparato
- Transporte
- Almacenamiento/Parada
- Cuidados y mantenimiento
- 9.1 Indicaciones generales
- 9.2 Revestimientos
- 9.3 Batería
- 9.4 Intervalos de mantenimiento
- 9.5 Trabajos de inspección y mantenimiento
- 9.5.1 Indicaciones generales de seguridad
- 9.5.2 Asegurar el recipiente para la suciedad levantado
- 9.5.3 Verificación del nivel de aceite del motor y rellenado
- 9.5.4 Cambiar el aceite del motor y el filtro de aceite del motor
- 9.5.5 Comprobar el nivel de líquido de frenos
- 9.5.6 Comprobar el nivel de aceite hidráulico y rellenar
- 9.5.7 Sustituir el filtro de aceite hidráulico
- 9.5.8 Comprobar el nivel de refrigerante y rellenar
- 9.5.9 Cambiar y limpiar el filtro de aire
- 9.5.10 Lubricar el vehículo
- 9.6 Cambiar los cepillos
- 9.7 Cambiar los cepillos laterales
- 9.8 Limpieza
- 9.8.1 Limpiar / cambiar los cartuchos de filtrado de polvo
- 9.8.2 Limpiar / cambiar el filtro plegado plano
- 9.8.3 Limpiar el vehículo
- 9.8.4 Limpieza del depósito de agua sucia
- 9.8.5 Limpiar el depósito de agua fresca
- 9.8.6 Limpiar los labios de sellado, la barra de aspiración y las boquillas de pulverización
- 9.8.7 Limpiar el recipiente para la suciedad
- 9.8.8 Limpiar el filtro de agua
- 9.8.9 Limpiar el radiadorde aceite hidráulico y el radiador del motor.
- 9.9 Cambios
- 9.10 Accesorios
- Subsanación de averías
- Datos técnicos
- 19
Dedust the dust filter daily. Several times a day as well
when working in extremely contaminated areas.
ATTENTION
Risk of damage!
Never set the filter dedusting switch to continuous op-
eration.
Switch off the suction blower before dedusting.
For dedusting, press the filter dedusting switch 4 - 5
times for approx. 5 seconds (no continuous operation!).
Stop the machine.
Switch off the brushes.
Note
The brushes lift up.
The side-brushes lift up.
Switch off suction blower.
Dedust the dust filter with the filter dedusting switch
(see Chapter "Cleaning | Dedusting the dust filter".
Empty waste container.
(see Chapter "Sweeping | Emptying the waste contain-
er")
Clean the device and the waste container daily after
work.
(see Chapter "Cleaning").
DANGER
Risk of injury!
During the entire emptying process, make sure that no
persons or animals are located nearby (waste contain-
er swivels out).
DANGER
Risk of crushing!
Never reach into the rod assembly for the drainage
mechanism. Do not stay under the raised container.
DANGER
Danger of tipping!
Place the device on an even surface during the empty-
ing process.
DANGER
Danger of tipping!
Do not drive long distances with the waste container
raised, drive slowly!
NOTICE
The container can only be tilted and emptied once a set
minimum level has been reached.
The high emptying system of the appliance allows the di-
rect disposal of the waste in the waste container into a re-
fuse container (for maximum unloading height see Chapter
"Technical data").
1 Waste container
2 Flap of waste container
3 Safety support
Use only with cleaning and maintenance work
4 Raising/lowering high emptying of waste container
5 Open/close flap of the waste container
During the entire emptying process, make sure that no
persons or animals are located nearby (waste contain-
er swivels out).
Position the device approximately in front of the collec-
tion container.
Close the waste container flap (display lamp must be il-
luminated).
Actuate the lever and raise the waste container.
With the waste container raised, move slowly over the
collection container.
Open the flap and empty the waste container.
ATTENTION
Remain seated calmly during the entire emptying proce-
dure (do not stand up from the driver seat), otherwise there
is a danger of the seat contact switch switching off during
the emptying procedure.
Park the machine on an even surface.
Park the machine in a safe and dry place.
Turn ignition key to "0" and remove it.
Note
With LPG devices, a switch-off delay lasting a few sec-
onds may occur.
Activate parking brake.
For additional information on shutting down the device,
see the Chapter "Storage/decommissioning".
6.3.1.1 Cleaning the dust filter
6.3.2 Stopping sweeping
6.3.2.1 After cleaning
6.3.3 Emptying waste container
6.4 Turn off device
20 EN










