Operating instructions
Table Of Contents
- English
- Contents
- Information about the vehicle
- Safety instructions
- 3.1 Notes on unloading/unpacking
- 3.2 General notes on safety
- 3.3 Work clothing
- 3.4 Safety instructions concerning the operation
- 3.5 Safety information concerning the driving operation
- 3.6 Safety guidelines for LPG vehicles (only gas engine)
- 3.7 Safety information concerning the combustion engine
- 3.8 Safety information concerning the transport of the vehicle
- 3.9 Safety information concerning maintenance and care
- 3.10 Safety Devices
- Overview of the appliance
- Start up
- Operation
- Transport
- Storage/decommissioning
- Care and maintenance
- 9.1 General notes
- 9.2 Cowlings
- 9.3 Battery
- 9.4 Maintenance intervals
- 9.5 Inspection and maintenance work
- 9.5.1 General notes on safety
- 9.5.2 Secure raised waste container
- 9.5.3 Check engine oil level and top up, if required
- 9.5.4 Change the motor oil and the oil filter
- 9.5.5 Check brake fluid status
- 9.5.6 Check hydraulic oil level and refill oil
- 9.5.7 Replacing the hydraulic oil filter
- 9.5.8 Checking the coolant level and topping up coolant
- 9.5.9 Cleaning and replacing the air filter
- 9.5.10 Greasing the vehicle
- 9.6 Replacing brushes
- 9.7 Replacing side brushes
- 9.8 Cleaning
- 9.8.1 Cleaning/replacing dust filter cartridges
- 9.8.2 Cleaning/replacing the flat fold filter
- 9.8.3 Cleaning the vehicle
- 9.8.4 Clean the waste water tank
- 9.8.5 Clean the fresh water reservoir
- 9.8.6 Cleaning sealing lips, suction bar and spray nozzles
- 9.8.7 Clean the waste container
- 9.8.8 Clean water filter.
- 9.8.9 Clean the hydraulic oil cooler and the radiator
- 9.9 Replacement tasks
- 9.10 Accessories
- Troubleshooting
- Specifications
- Français
- Table des matières
- Indications relatives au véhicule
- Consignes de sécurité
- 3.1 Instructions pour le déchargement/ déballage
- 3.2 Consignes de sécurité générales
- 3.3 Vêtements de travail
- 3.4 Consignes de sécurité relatives à la commande
- 3.5 Consignes de sécurité relatives au mode de déplacement
- 3.6 Respecter les directives de sécurité technique pour les véhicules à gaz liquéfié (seulement moteur à gaz).
- 3.7 Consignes de sécurité relatives au moteur à combustion
- 3.8 Consignes de sécurité relatives au transport du véhicule
- 3.9 Consignes de sécurité relatives à l'entretien et à la maintenance
- 3.10 Dispositifs de sécurité
- Aperçu de l'appareil
- Mise en service
- Fonctionnement
- 6.1 Condition de roulage
- 6.2 Nettoyage au mouillé
- 6.3 Balayer
- 6.4 Mettre l'appareil hors tension
- Transport
- Stockage / arrêt
- Entretien et maintenance
- 9.1 Consignes générales
- 9.2 Habillages
- 9.3 Batterie
- 9.4 Consignes de sécurité
- 9.5 Fréquence de maintenance
- 9.6 Travaux de contrôle et de maintenance
- 9.6.1 Consignes de sécurité générales
- 9.6.2 Sécuriser la cuve à poussière en position soulevée
- 9.6.3 Vérification du niveau d'huile moteur et rajout
- 9.6.4 Changer huile de moteur et le filtre d'huile de moteur
- 9.6.5 Contrôler le niveau de liquide de frein
- 9.6.6 Contrôler le niveau d'huile hydraulique et ajouter de l'huile
- 9.6.7 Remplacer le filtre à huile hydraulique.
- 9.6.8 Vérifier le niveau de liquide de refroidissement et ajouter du liquide de refroidissement
- 9.6.9 Nettoyage et échange du filtre à air
- 9.6.10 Lubrifier le véhicule
- 9.7 Remplacer les brosses
- 9.8 Remplacer les balais latéraux
- 9.9 Nettoyage
- 9.9.1 Nettoyer / remplacer les cartouches de filtre à poussières
- 9.9.2 Nettoyer / remplacer le filtre plat plissé
- 9.9.3 Nettoyer le véhicule
- 9.9.4 Nettoyage du bac d'eau sale
- 9.9.5 Nettoyer le réservoir d'eau propre
- 9.9.6 Nettoyer les lèvres d'étanchéité, la barre d'aspiration et les buses de pulvérisation
- 9.9.7 Nettoyer la cuve à poussière
- 9.9.8 Nettoyer le filtre à eau
- 9.9.9 Nettoyer le refroidisseur d'huile hydraulique et le radiateur du moteur.
- 9.10 Travaux de remplacement
- 9.11 Accessoires
- Service de dépannage
- Caractéristiques techniques
- Español
- Índice de contenidos
- Indicaciones sobre el vehículo
- Indicaciones de seguridad
- 3.1 Indicaciones para la descarga/ desembalaje
- 3.2 Indicaciones generales de seguridad
- 3.3 Ropa de trabajo
- 3.4 Indicaciones de seguridad para el manejo
- 3.5 Indicaciones de seguridad para el modo de desplazamiento
- 3.6 Observe las directivas de seguridad para vehículos a gas licuado (solo motor de gas)
- 3.7 Indicaciones de seguridad para el motor de combustión
- 3.8 Indicaciones de seguridad para el transporte del vehículo
- 3.9 Indicaciones de seguridad para cuidar y mantener
- 3.10 Dispositivos de seguridad
- Vista general del aparato
- Puesta en marcha
- Funcionamiento
- 6.1 Manejo
- 6.2 Limpieza en húmedo
- 6.3 Barrido
- 6.4 Parar el aparato
- Transporte
- Almacenamiento/Parada
- Cuidados y mantenimiento
- 9.1 Indicaciones generales
- 9.2 Revestimientos
- 9.3 Batería
- 9.4 Intervalos de mantenimiento
- 9.5 Trabajos de inspección y mantenimiento
- 9.5.1 Indicaciones generales de seguridad
- 9.5.2 Asegurar el recipiente para la suciedad levantado
- 9.5.3 Verificación del nivel de aceite del motor y rellenado
- 9.5.4 Cambiar el aceite del motor y el filtro de aceite del motor
- 9.5.5 Comprobar el nivel de líquido de frenos
- 9.5.6 Comprobar el nivel de aceite hidráulico y rellenar
- 9.5.7 Sustituir el filtro de aceite hidráulico
- 9.5.8 Comprobar el nivel de refrigerante y rellenar
- 9.5.9 Cambiar y limpiar el filtro de aire
- 9.5.10 Lubricar el vehículo
- 9.6 Cambiar los cepillos
- 9.7 Cambiar los cepillos laterales
- 9.8 Limpieza
- 9.8.1 Limpiar / cambiar los cartuchos de filtrado de polvo
- 9.8.2 Limpiar / cambiar el filtro plegado plano
- 9.8.3 Limpiar el vehículo
- 9.8.4 Limpieza del depósito de agua sucia
- 9.8.5 Limpiar el depósito de agua fresca
- 9.8.6 Limpiar los labios de sellado, la barra de aspiración y las boquillas de pulverización
- 9.8.7 Limpiar el recipiente para la suciedad
- 9.8.8 Limpiar el filtro de agua
- 9.8.9 Limpiar el radiadorde aceite hidráulico y el radiador del motor.
- 9.9 Cambios
- 9.10 Accesorios
- Subsanación de averías
- Datos técnicos
- 15
몇
CAUTION
Risk of damage!
The brush used must be suitable for cleaning the floor.
Do not operate the brushes on the spot.
ATTENTION
To achieve an optimum cleaning result, the driving speed
should be adjusted to take specific situations into account.
Wet cleaning is very simple. Roller brush and side scrub-
bing deck are to be used for this cleaning task (no side
brushes deck and no roller brush).
A distinction is made between two types of wet cleaning.
– Basic cleaning
– Regular cleaning
Basic cleaning
Basic cleaning is comprised of two procedures and is ap-
plied with extremely contaminated or stubborn dirt.
In the first procedure, the contamination is dissolved by
the counter-rotating cleaning brushes with cleaning so-
lution added. The cleaning solution remains on the floor
afterwards and can react in the dirt.
Note
The suction turbine is switched off and the suction bar
remains raised.
Keep the flap of the waste container closed
In the second and next procedure, maintenance clean-
ing is applied.
Regular cleaning
The maintenance cleaning is applied during daily cleaning.
For this, cleaning is performed in a single procedure
with cleaning brush, lowered suction bar and sweeping
blower switched on. This kind of cleaning leaves behind
a dry floor that can be walked on afterwards.
Note
Keep the flap of the waste container closed
1 Fresh water tank
2 Fresh water tank cover
3 Filling level display
Open the cover of the fresh water reservoir.
Fill fresh water tank with fresh water (maximum 50°C).
Add detergent. Follow dosing instructions for detergent.
Close the cover of the fresh water reservoir.
몇 WARNING
Risk of damage!
Only use cleaners recommended by the manufacturer
and comply with their application, disposal and warning
guidelines.
More information about detergents can be found in the
data sheet (available from Kärcher) or in the notes on
the detergent container.
Only use detergents that are free from solvents, hydro-
chloric acid and hydrofluoric acid.
ATTENTION
Do not use highly foaming detergents.
6.2 Wet cleaning
6.2.1 Fill up fresh water reservoir
1
2
6.2.2 Recommended detergents
Application Detergent
Routine cleaning of all water resistant
floors
RM 745
RM 746
Routine cleaning of glossy surfaces (e.g.
granite)
RM 755 ES
Routine cleaning and basic cleaning of in-
dustrial floors
RM 69 ASF
Routine cleaning and basic cleaning of fine
stoneware tiles
RM 753
Routine cleaning of tiles in sanitary areas RM 751
Removal of coating from all alkali-resistant
floors (e.g. PVC)
RM 752
16 EN










