Operating instructions
Table Of Contents
- English
- Contents
- Environmental protection
- Danger or hazard levels
- Overview
- Symbols on the machine
- Proper use
- Safety instructions
- Safety Devices
- Start up
- GFCI INSTRUCTIONS
- Operation
- Opening/closing the trigger gun
- Replace the nozzle
- Turning on the Appliance
- Adjust cleaning temperature
- Set working pressure and flow rate
- Operation with detergent
- Cleaning
- Operating with cold water
- Eco operation
- Operating with hot water/steam
- Interrupting operation
- After operation with detergent
- Turn off the appliance
- Storing the Appliance
- Frost protection
- Shutdown
- Storage
- Transport
- Care and maintenance
- Troubleshooting
- Indicator lamp pump
- Indicator lamp rotation direction is blinking
- Indicator lamp "Ready for use" turns off
- Engine indicator lamp
- Indicator lamp burner failure
- Indicator lamp service
- Fuel indicator lamp glows
- Indicator lamp system care is illuminated
- Indicator lamp system care is blinking
- Indicator lamp detergent 1 is illuminated
- Indicator lamp detergent 2 is illuminated
- Appliance is not running
- Device is not building up pressure
- Device leaks, water drips from the bottom of the device
- Device turns on and off while hand spray gun is closed
- Device is not sucking in detergent
- Burner does not start
- Set temperature is not achieved while using hot water
- Customer Service
- Warranty
- Accessories and Spare Parts
- Technical specifications
- Français
- Table des matières
- Protection de l’environnement
- Niveaux de danger
- Aperçu général
- Symboles sur l'appareil
- Utilisation conforme
- Consignes de sécurité
- Dispositifs de sécurité
- Mise en service
- Monter la poignée
- Fixer l'enjoliveur de roue
- Remplir l'entretien système
- Régler le dosage de l'entretien système Advance RM 110/RM 111
- Remplissage du combustible
- Faire le plein de détergent
- Monter pistolet pulvérisateur à main, lance, buse et flexible haute pression
- Arrivée d'eau
- Aspirer l'eau encore présente dans les réservoirs
- Raccordement électrique
- DISJONCTEUR DIFFERENTIEL
- Utilisation
- Ouvrir/fermer le pistolet de pulvérisation à main
- Remplacer la buse
- Mettre l'appareil en marche
- Régler la température de nettoyage
- Régler la pression de service et le débit
- Fonctionnement avec détergent
- Nettoyage
- Utilisation avec de l'eau froide
- Fonctionnement Eco
- Utilisation avec de l'eau chaude/de la vapeur
- Interrompre le fonctionnement
- Après utilisation avec un détergent
- Mise hors service de l'appareil
- Ranger l’appareil
- Protection antigel
- Remisage
- Entreposage
- Transport
- Entretien et maintenance
- Assistance en cas de panne
- Lampe témoin pompe
- La lampe témoin sens de rotation clignote
- Le témoin de contrôle d’état de service s'éteint
- Témoin de contrôle Moteur
- Voyant de contrôle Défaut de brûleur
- Lampe témoin service
- Le témoin de contrôle Combustible s'allume
- La lampe témoin soin système est allumée
- La lampe témoin soin système clignote
- La lampe témoin détergent 1 est allumée
- La lampe témoin détergent 2 est allumée
- L'appareil ne fonctionne pas
- L'appareil n'établit aucune pression
- L'appareil présente un fuit, de l'eau s'écoule de l'appareil par le bas
- Lorsque la poignée-pistolet est fermée, l'appareil ne cesse de se mettre sous et hors tension
- L'appareil n'aspire pas de détergent
- Le brûleur ne s'allume pas
- Lorsque l'appareil est utilisé avec de l'eau chaude, il n'atteint pas la température réglée
- Service après-vente
- Garantie
- Accessoires et pièces de rechange
- Caractéristiques techniques
- Español
- Índice de contenidos
- Protección del medio ambiente
- Niveles de peligro
- Resumen
- Símbolos en el aparato
- Uso previsto
- Indicaciones de seguridad
- Dispositivos de seguridad
- Puesta en marcha
- Montar el estribo de manejo
- Fijar los tapacubos
- Rellenar producto de mantenimiento
- Ajustar la dosis de producto para cuidado del sistema Advance RM 110/RM 111
- Llenar de combustible
- Llenar de detergente
- Montar la pistola pulverizadora manual, lanza dosificadora, boquilla y manguera de alta presión
- Conexión de agua
- Aspirar agua del depósito
- Toma de corriente
- Instrucciones del Interruptor de Circuito de Avería por Puesta a Tierra
- Manejo
- Abrir/cerrar la pistola pulverizadora
- Cambiar las boquillas
- Conexión del aparato
- Regular la temperatura de limpieza
- Ajustar la presión de trabajo y el caudal
- Funcionamiento con detergente
- Limpieza
- Servicio con agua fría
- Funcionamiento Eco
- Servicio con agua caliente/vapor
- Interrupción del funcionamiento
- Después del funcionamiento con detergente
- Desconexión del aparato
- Almacenamiento del aparato
- Protección antiheladas
- Parada
- Almacenamiento
- Transporte
- Cuidados y mantenimiento
- Ayuda en caso de avería
- Piloto de control de la bomba
- El piloto de control dirección de giro parpadea
- El piloto de control de disposición de servicio se apaga
- Piloto de control del motor
- Piloto de control de avería en el quemador
- Piloto de control revisión
- El piloto de control de combustible está encendido
- El piloto de control del producto de cuidado del sistema se enciende
- El piloto de control del producto de cuidado del sistema parpadea
- El piloto de control de detergente parpadea una vez
- El piloto de control de detergente parpadea dos veces
- El aparato no funciona
- El aparato no genera presión
- El aparato tiene fugas, el agua gotea del aparato por abajo
- El aparato se enciende y se apaga continuamente cuando la pistola está cerrada
- El aparato no succiona detergente
- El quemador no se enciende
- La temperatura regulada no se alcanza durante el servicio con agua caliente
- Servicio de atención al cliente
- Garantía
- Accesorios y piezas de repuesto
- Datos técnicos
몇 WARNING
When using this product basic precautions
should always be followed, including the
following:
1 Read all the instructions before using
the product.
2 High pressure jets can be dangerous if
misused. The jet must not be directed at
persons, animals, electrical devices, or
the unit itself.
3 To reduce the risk of injury, close super-
vision is necessary when a product is
used near children.
4 Know how to stop the product and
bleed pressures quickly. Be thoroughly
familiar with the controls.
5 Stay alert – watch what you are doing.
6 Wear safety goggles.
7 Do not use acids, alkaline, solvents, or
any flammable material in this product.
These products can cause physical in-
juries to the operator and irreversible
damage to the machine.
8 Do not operate the product when fa-
tigued or under the influence of alcohol
or drugs.
9 Do not overreach or stand on unstable
support. Keep good footing and bal-
ance at all times.
10 To reduce the risk of electrocution,
keep all connections dry and off the
ground. Do not touch plug with wet
hands.
11 The Trigger Gun Safety Lock prevents
the trigger from accidentally being en-
gaged. This safety feature DOES NOT
lock trigger in the ON position.
12 Keep operating area clear of all persons.
13 Close cover before operating the ma-
chine.
14 This appliance is intended for commer-
cial use.
15 Follow the maintenance instructions
specified in the manual.
16 This machine has been designed for
use with cleaning chemicals supplied or
recommended by the manufacturer.
The use of other cleaning chemicals
may affect the operation of the machine
and void the warranty.
17 HDS 3.5, 4.0, 4.5 only:
This product is provided with a Ground
Fault Circuit Interrupter built into the
power cord plug. If replacement of the
plug or cord is needed, use only identi-
cal replacement parts.
18 HDS 3.5, 4.0, 4.5 only:
Do not use extension cord with this
product.
– Injection hazard: equipment can cause
serious injury if the spray penetrates the
skin. Do not point the gun at anyone or
any part of the body. In case of penetra-
tion seek medical aid immediately.
– This system is capable of producing
2300 psi/15.9 MPa (HDS 3.5/23) -
3000 psi/20.7 MPa (HDS 3.5/30, HDS
5.0/30) - 2000 psi/13.8 MPa (HDS 4.0/
20) - 2250 psi/15.5 MPa (HDS 4.5/22).
To avoid rupture and injury, do not op-
erate this pump with components rated
less than 2300 psi/15.9 MPa (HDS 3.5/
23) - 3000 psi/20.7 MPa (HDS 3.5/30,
HDS 5.0/30) - 2000 psi/13.8 MPa (HDS
4.0/20) - 2250 psi/15.5 MPa (HDS 4.5/
22) working pressure (including but not
limited to spray guns, hose and hose
connections).
– Before servicing, cleaning, or removal
of any part, shut off power and relieve
pressure.
– Do not spray electrical apparatus and
wiring.
– High Pressure. Keep clear of nozzle.
– If connection is made to a potable water
system, the system shall be protected
against backflow.
IMPORTANT SAFETY INSTRUCTIONS
6 EN