Operating instructions

- 33
1 Condensate drain valve
 Hold the condensate drain valve over a
duct or a collection container.
 Open the condensate drain valve and
drain the condensate.
 Close the condensate drain valve.
1 Screw
2 Halves of the handle shell
3 Node piece
4 Needle bearing
5 O ring
6 Contact surface pipe/ handle shell
7 high pressure hose
 Unscrew spray pipe.
 Loosen 6 screws.
 Remove the half of the handle shell.
 Fill grease in the needle bearing cham-
ber in the handle shell.
 Grease needle bearing and O-Ring.
 Grease contact surface pipe/ handle
shell.
 Screw back the two halves of the han-
dle shell.
1 Screw
2 Nozzle holder
3 Light sensor
4 Cover
5 Looking glass
6 Pressure plate
 Loosen fuel pipe.
 Pull out the light sensor sideways from
the holder.
 Loosen 3 screws.
 Remove the lid with the holder for light
sensor.
 Remove the pressure plate from the
nozzle holder.
 Clean the looking glass.
 Assemble the parts in the reverse se-
quence.
1 Fuel pump
2 Filter casing
 Lock the oil supply.
 Unscrew the filter casing.
 Clean filter with compressed air.
 Assemble the parts in the reverse se-
quence.
 Open the oil supply.
몇 WARNING
Risk of burns due to hot oil or hot parts of
the plant. Allow the pump to cool down for
minutes before oil change.
Note:
Used oil must only be disposed of by the
designated collection points. Please turn in
used oil there. Polluting the environment
with used oil is prosecutable.
1 Oil container lid
2 Oil drain screw
 Keep a collection basin for old oil ready.
 Remove the lid of the oil container.
 Unscrew the oil drain screw and collect
used oil.
 Insert washer and turn in the oil drain
screw.
 Slowly fill in new oil until the "MAX"
marking on the oil container.
 Close the oil container with the lid.
 Deliver the old oil to the respective col-
lection centres.
 Open the coin acceptor, and clean the
coin channel with a moist cloth and
washing liquid.
The correct setting of the ignition elec-
trodes is very important for the burner to
function properly. The settings have been
indicated in the above drawing.
Maintenance Works
Draining condensate at the compressor
Lubricate the hand-spray gun
Clean looking glass for flame
monitoring
Cleaning the fuel pump filter
Oil change
Clean the coin mechanism
Electrode setting
35EN