Operating instructions

– 8
Illustration
 Place the appliance in the cleaning station.
Illustration
 Remove the fresh water tank from the appliance
using the handle.
Illustration
 Open fuel filler cap.
 Fill the fresh water tank with cold or lukewarm tap
water.
 Add cleaning or disinfecting agent as required.
 Do not exceed the "MAX" marking when filling.
 Close tank lock.
Illustration
 Insert the fresh water container into the appliance.
The fresh water tank must sit snugly into the appli-
ance.
ATTENTION
The water level must be checked at regular intervals to
prevent the waste water tank from overflowing. Do not
exceed the "MAX" marking.
Illustration
 Place the appliance in the cleaning station.
Illustration
 Hold the waste water tank at the bottom handle. At
the same time, press the upper handle downwards
with your thumbs.
 Remove waste water tank.
Illustration
 Remove the cover from the waste water tank.
 Empty the waste water tank.
 Depending on the amount of dirt, clean the lid/sep-
arator and waste water tank with tap water.
 Place the lid on the waste water tank.
The lid must sit snugly onto the waste water tank.
Illustration
 Insert the waste water tank into the appliance.
The waste water tank must sit snugly in the appli-
ance.
Illustration
 Switch off the appliance; press the on/off button to
do so.
Illustration
 Place the appliance in the cleaning station.
ATTENTION
To ensure the stability of the appliance during down-
time, always put the appliance into the cleaning/park
station. A lack of stability can cause the appliance to
topple over, which can cause fluid to leak that damages
the floor covering.
Illustration
 Switch off the appliance; press the on/off button to
do so.
Illustration
 Place the appliance in the cleaning station.
Illustration
ATTENTION
After completing the work, clean the appliance by apply-
ing a rinse cycle.
See "Cleaning the appliance by rinsing".
Illustration
 Completely empty the appliance.
Illustration
until
Illustration
 Empty the waste water tank.
See Chapter "Emptying the waste water tank".
 If there is still water in the fresh water tank or clean-
ing station, empty it.
Illustration
 Disconnect the main plug from the socket.
Illustration
 Wind the mains cable around the cable clips.
 Secure the mains cable with the cable clip.
ATTENTION
To prevent odours developing, the fresh water and
waste water tank must be completely emptied prior to
storing the appliance.
Illustration
 Move the appliance to the place of storage using
the carrying handle.
Illustration
 To
stabilise, place the appliance into the cleaning
station.
 Store the appliance in a dry room.
ATTENTION
When the work is finished, always rinse the appliance
through with the cleaning station and fresh water. This
is the best way of cleaning the appliance. It prevents the
build-up of dirt and bacteria or unpleasant odours.
Illustration
 Switch off the appliance; press the on/off button to
do so.
Illustration
 Place the appliance in the cleaning station.
 For the rinsing process, fill the fresh water tank with
cold or lukewarm tap water to completely remove
detergent residue from the suction ducts and slits
on the suction head.
Illustration
 Insert the fresh water container into the appliance.
Illustration
 Remove the waste water tank and empty it.
See Chapter "Emptying the waste water tank".
 Fill the measuring cup with 200 ml water.
 Fill the cleaning station with water.
 If necessary, add appropriate KÄRCHER cleaning
agents for the rinsing procedure.
 To switch on the appliance press the on/off switch.
 Allow the appliance to run for 30-60 seconds until
the water is completely drawn out of the cleaning
station.
The rinsing procedure is now complete.
Note
The longer the appliance is switched on, the less resid-
ual moisture is left over in the cleaning rollers.
 Switch off the appliance; press the on/off button to
do so.
 If there is still water in the fresh water tank, remove
the fresh water tank and empty it.
Illustration
 Empty the waste water tank.
See Chapter "Emptying the waste water tank".
Emptying the waste Water tank
Interrupting operation
Turning Off the Appliance
Storing the Appliance
Care and maintenance
Cleaning appliance with rinsing process
15EN