Operating instructions

15
Maintenance
Machine Troubleshooting
PROBLEM CAUSE SOLUTION
Machine will not run
Circuit breaker tripped in building. Check and reset.
Power switch failure
Test switch for continuity and
replace if necessary.
Tripped circuit breaker Reset.
Faulty power cord Replace.
Electrical shock
Equipment not grounded
Follow grounding instructions
exactly.
Receptacle not grounded
Have an electrician inspects
building’s wiring.
Internal wiring problem
Ensure that the machine wiring
matches the appropriate wiring
diagram. Replace any wires or
components that are short circu-
iting.
Repeated circuit breaker tripping
Mechanical problem
Higher amp draws indicate a
mechanical problem. Find the
problem before using the machine.
Faulty circuit breaker
Test circuit for continuity. Replace
circuit breaker if necessary.
Excessive vibration
Pad not centered Re-center pad.
Damaged or unevenly worn pad
Replace pad. Do not rest machine
on pad when not in use.
Damaged pad driver Replace.
Pad does not turn but motor is
running
Belt is loose or broken Adjust or replace belt.
86387270 Operator’s Manual - Floor Burnisher (1500 Series)