Operating instructions

19
Operation
Machine Operation
Pre-Run Machine Inspection
Do a pre-run inspection to find possible problems that
could cause poor performance or lost time from break-
down. Follow the same procedure each time to avoid
missing steps.
NOTE: See maintenance section for pre-run machine
inspection checklist items.
Starting Machine
NOTE: Perform pre-run machine check before
operating machine.
FOR SAFETY: Before starting machine, make sure
that all safety devices are in place and operating
properly.
2. Disconnect or unplug battery charger.
3. Close the cover(s).
4. Verify condition of burnishing pad, replace if neces-
sary.
5. Verify removable pad driver is installed correctly
and pad rotation lock is released.
6. The operator should be on the pedal platform. The
throttle pedal must be in the neutral position.
7. Turn the machine power on by turning key switch
clockwise to the “ON” position.
8. Verify dust collection bag is installed.
9. Press the Drive Reset Directional Control Switch to
reset and set the intended direction for travel.
10. Press lightly on the throttle pedal with right foot
Emergency Stop Procedure
Push in emergency stop button. This will also engage
the parking brake and cause the machine to stop imme-
diately.
Operating the Machine
When operating the machine around people, pay close
attention for unexpected movement. Use extra caution
around children.
1. Stand on the operator platform. Throttle pedal must
be in neutral position.
2. Turn machine power on.
3. Select transport speed from Function Mode Switch.
4. Press the Drive Reset/Directional Control Switch,
selecting the desired travel direction.
5. Select Light burnishing or Deep burnishing from
the Function Mode Switch. Deck will Lower.
6. The pad motor will only run when the burnishing
head is lowered to within 2 inches of the floor.
7. Occasionally verify “check pad” indicator light is
“green”. If not, stop machine, remove pad driver
and check pad. Replace or flip as needed.
NOTE: To prevent possible damage to the floor
surface, always keep the machine moving while the
pad is spinning.
8. When the head is down and the machine is
propelled, the pad motor runs.
When the battery light flashes it indicates discharged
batteries, stop operation and charge batteries.
86446780 Operator Manual - Chariot 2 iGloss 20