Operating instructions

Maintenance

Troubleshooting

PROBLEM CAUSE SOLUTION

Vacuum motor does not run, or

runs slowly

Faulty vacuum circuit or switch Check wires & connections

Worn vacuum motor brushes Replace brushes, check commutator

Vacuum circuit breaker tripped Reset circuit breaker

Vacuum and brush do not turn on Circuit breaker tripped Reset

Full bag or clog in system (bag full light

on)

Replace bag, empty debris tray, check

for and remove clogs

Poor vacuum performance Debris caught in system Remove debris

Low battery charge Charge batteries

Lid is not closed correctly Close and latch lid correctly

Faulty gaskets inspect and replace gaskets

Accessory hose is not sealed shut. assure hose is tight in hose holder

Bag or debris tray are full Empty tray, replace bag

Vacuum diverter valve not actuating Check for debris

Check electrical connections

Check timer circuit board

Brush motors do not run, or runs

slowly

Circuit breaker tripped Reset circuit beaker

Low battery charge Charge battery

Faulty brush circuit or motor Check wires, connections and motor

Bag full light on

Replace bag, empty debris tray or

remove clog.

Worn brush motor brushes

Replace brushes, check commutator

Deck won’t go down Actuator circuit breaker tripped Reset actuator circuit breaker

Side broom not running Fuse is blown

Clear foreign objects from broom that

inhibit free motion, replace fuse.

Brush door won’t close

Cylindrical brushes not installed

correctly.

Align brushes to drive shaft assem-

blies, close door.

8.644-676.0 Operator’s Manual - iVac 24 ATV